Electronics Forum | Mon Mar 27 15:10:48 EST 2006 | ms
Hi Steve Thanks for your reply. Your comments make it sound like it may be the nature of this paste. Any one else agree? Paste control is fairly good. Paste is put in fridge straight after it arrives at inwards goods, (4deg). Removed from fridge
Electronics Forum | Tue Dec 08 08:52:42 EST 2009 | cunningham
How do people prepare there solder paste for screen print? We currently remove them from the fridge and mix them in a 500g solder paste tub mixer to mix the flux and paste together we waste to much paste at the moment as we only use the tub for 1
Electronics Forum | Tue Feb 17 01:12:52 EST 1998 | J.H. Kim
In solder bumping in flipchip technology by splder printing, the precise control of solder volume and height is very difficult. Therefore I'd like to know the solution of this problem. Thanks
Electronics Forum | Wed Dec 09 09:47:32 EST 2009 | dyoungquist
I am curious as to why you need to mix.... We use a 500g cartridge with air gun. Our process is remove the cartridge from the fridge, allow it to warm up to room temperature before inserting into air gun, then apply bead of paste to the stencil. N
Electronics Forum | Fri Dec 11 09:51:56 EST 2009 | dyoungquist
I won't say never but very rarely do we have problems with the flux seperating. The way we get around the 1-2 hour warmup time is this: The day before we run a particular job, the last person takes out the paste needed from the fridge as the last t
Electronics Forum | Sun May 05 12:06:22 EDT 2013 | mbb
Hello, I'm looking for a mechanical system for fifo management of solder paste in warehouse in order to eliminate human errors while putting solder paste jars in fridges.
Electronics Forum | Mon Mar 27 21:09:29 EST 2006 | ms
Thanks Dave I'm not convinced the air is necessarily in the paste from manufacture - suspicious that it may be folding in during the change in direction of the print cycle - or as the paste travels across apertures. It is not necessarily in the fir
Electronics Forum | Mon Mar 27 20:53:12 EST 2006 | davef
If you believe: * There is air in your paste AND * You are not whipping the air into the paste ... You should: * Return the paste to your supplier * Get it replaced * Begin qualifying a replacement supplier. One thing before you go racing off to ly
Electronics Forum | Mon Mar 27 20:34:22 EST 2006 | ms
Thanks for the suggestion. The large ground pad appears as a single large pad on the component and PCB but we print a matrix of 28 small dots of paste to provide the solder for the joint. The inconsistent volume transfer can occur on any of the fo
Electronics Forum | Sun Mar 26 19:02:05 EST 2006 | ms
Hi We are running automatic stencil printers, open squeegees, stainless stencil, stainless blades, print speed 25-30mm/sec. We have a frustrating consistency issue printing .37x.3mm apertures on a 45pin LGA (11 pads each side, 1 large ground in mid
.gif)
