Electronics Forum | Thu Apr 26 09:03:35 EDT 2007 | ck_the_flip
3d is good for initial verification that your screen printer and stencil is producing the desired paste height. 2D verification is more than sufficient during regular production. That being said, your best bet for a 3D machine is to go cheap - buy
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Tue Nov 18 21:18:29 EST 2014 | sonavc
Thanks, I don't have change to try the Password Now my machine boot up and get " BLUE SCREEN " I screw up my windows NT. Does any one know who till service this machine, reinstall the software and application. I'm in Southern California , CA 92708
Electronics Forum | Sat Oct 25 13:36:39 EDT 2014 | sonavc
Hi everyone, hope you can help me with this machine I bought used and after it is set up , it runs good, home position. I can click the tab Start, and Setup. But I can't click the tab I/O , edit or system. Because, I think I can't log in the Level
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
Electronics Forum | Tue Nov 08 18:27:50 EST 2011 | dekhead
Not a lot of info; first thought is 12VDC - PSU, breaker, fuse http://www.dekhead.com
Electronics Forum | Thu Apr 26 01:14:42 EDT 2007 | JJ
Hi all, We plan to buy solder paste height measurement machine. However, not sure which is the better one..2D or 3D? As far as I know,3D is quite slow and but more accurate in term of measurement result. Pls share with me if anyone who has this e
Electronics Forum | Thu Apr 26 13:17:10 EDT 2007 | jerrysaise
�It adds NO VALUE whatsoever to do 3D inspection as part of in-line production.�
Electronics Forum | Thu Apr 26 01:42:56 EDT 2007 | Haris
Hi, yes may be 3d is slow but it gives you great results as it shows the height while 2d picture shows error when the paste in your machine appears to end i.e. when it see that the pad starts to appear. I don't know which company brand you prefer but
Electronics Forum | Thu Apr 26 11:40:10 EDT 2007 | CL
Good Morning, We have a 3D solder paste inspection machine. We purchased it on a recommendation from a consultant. We are a CM high mix low volume. The President of my company has attended some seminars and meetings where it was conveyed to her that
.gif)
