Electronics Forum | Tue Nov 02 03:24:33 EDT 2010 | Jacki
Yes, we use solder paste,solder bar and solder wire from different manufactureres for 1PCB assembly. And, what JAX said, we never mixed solder paste from different manufactures and used.
Electronics Forum | Tue Nov 02 07:42:30 EDT 2010 | jdengler
Will the flux residue from solder paste A come into contact with flux from solder paste B? If so you better do some tests. There is always a possibility of a bad reaction between 2 fluxes. You need to test to make sure. Jerry
Electronics Forum | Mon Nov 01 16:22:47 EDT 2010 | jax
Who Cares... Mix Away! Although you should not mix different Solder Pastes' together in a container or on a stencil (Mostly due to the flux, although solder sphere size and shape could cause an issue), mixing solder brands or chemistries on a board
Electronics Forum | Mon Nov 01 13:43:18 EDT 2010 | jmatty35
I have a question regarding mixing different manufacturers solder pastes. We have a board being built by a CM that we are bringing in house and soldering a final cover onto the PCB. The contract manufacturer is using solder paste A. We want to use
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
Electronics Forum | Tue Nov 08 18:27:50 EST 2011 | dekhead
Not a lot of info; first thought is 12VDC - PSU, breaker, fuse http://www.dekhead.com
Electronics Forum | Mon May 12 11:59:12 EDT 2008 | vms
todd the best answer is this" don't use the dispenser it will waste to much solder paste" Harry
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Tue Oct 28 14:18:41 EDT 2014 | tombstonesmt
Spoke to the maintenance manager, master password is the current date in reverse. For example : Today is 10/28/2014 so... 41028201 Level 3 should be pass3. Hope this helps.
winsouce.jpg)
