Electronics Forum | Thu Mar 04 07:35:38 EST 2010 | rajeshwara
Plz tell me Stencil Thickness ? Solder Paste ? Mesh Size ? Partcle size/type? Viscosity?
Electronics Forum | Wed Feb 15 10:59:58 EST 2023 | wippsen
the viscosity of the paste is too high, printing parameter is not the problem. did you use old solder?
Electronics Forum | Mon Sep 17 15:27:51 EDT 2001 | jschake
Challenges: The basic defects that impact assembly yield are bridging, satellite solder balls, and opens (i.e. tombstones / draw bridges). There are many variables with the stencil printing process that can impact these; several of them are listed
Electronics Forum | Wed Feb 23 00:45:49 EST 2011 | tsvetan
Does someone with technical knowledge knows what exactly happend with the solder paste after the shelf life pass? What we have seen is sometimes flux separation which disapear after a good mix, and change of viscosity i.e. drying. The tin, silver and
Electronics Forum | Fri Jan 21 11:00:56 EST 2011 | xps
Hi, in my experience, the humidity is trapped in the solder paste. Otherwise you can also try to : adjust preheat profile, and /or increase paste viscosity, and /or increase paste metal content (they are the most common causes).
Electronics Forum | Wed Dec 08 11:26:04 EST 2010 | davef
3 Printer Area Conditions * As stated earlier, heat and humidity are damaging to solder paste. Ideally, the printing area should be maintained at 40% - 50% relative humidity and 72°- 80°F (22-26°C). In addition, no air (cool or warm) should blow dire
Electronics Forum | Mon Jan 09 19:55:32 EST 2006 | davef
"Poor release" (paste hanging-up in the stencil holes) could have three main (or combination of) causes: 1 Equipment * Proper aperture area ratio provide better release * Laser cut release better than chemical etched stencil 2 Process * Snap-off dis
Electronics Forum | Tue Aug 01 08:52:53 EDT 2006 | davef
We never changed any thing after moving to imm silver. "Poor release" (paste hanging-up in the stencil holes) could have three main (or combination of) causes: 1 Equipment * Proper aperture area ratio provide better release * Laser cut release bette
Electronics Forum | Mon Jul 26 11:01:35 EDT 1999 | Kevin Hussey
| Has anyone ever heard of testing solder paste quality by pasting a board and making a determination of the quality by measuring paste height and width after the board is pasted. Would you consider this a valid test for solder paste testing? | I ha
Electronics Forum | Sat Jun 25 00:52:31 EDT 2005 | ktron
Hi all, Recently I had problem with printing the lead free solder paste, almost every board has bridging especially on the fine pitch locations. Anyway this problem never happens when we use leaded solder paste. So I would like to ask if there are a
