Electronics Forum | Mon Mar 07 09:23:25 EST 2016 | rgduval
We've had our My500 for about four months now, and couldn't be happier. We are a super-high-mix, super-low-volume shop, and the flexibility provided by the 500 over stencils is stunning. So, you buy 5-10 stencils a week? That's 260-520 stencils a
Electronics Forum | Sat Oct 10 04:58:18 EDT 1998 | Tony B
| *Reply to: ericr@nj.tanon.com | | Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Wed May 22 16:36:13 EDT 2002 | slthomas
What methods do you guys use for maintaining lot and/or board traceability? When I worked in med. products, we used travelers that we recorded everything on, then serialized them at the end of the build. Not as effective as up front serialization,
Electronics Forum | Tue Nov 01 15:26:43 EST 2005 | GS
Is it this your first experience of C-CGA RWK ? In order to approach a RWK of this kind of pakage it requires a capable process and clear operating procedure. In the past, the company who I use to work for, we rwkd plenty of this kind of CCGA. Earl
Electronics Forum | Fri Jul 30 20:11:35 EDT 1999 | Mike Konrad
It is true that the use of saponifiers (and other water soluble additives) will lower the surface tension and aid in under component penetration. It is also true, however, that other specific design features within a batch machine can also aid in un
Electronics Forum | Mon Nov 29 11:37:51 EST 1999 | cpitarys
Hello Jason, I will look for the best price and service support to start. Also request an in house trial at the vendor. Jason, are you looking to remove a no clean paste or water soluble paste? Single Chamber Equipment: Most stencil cleaners opera
Electronics Forum | Mon Feb 01 09:17:45 EST 2016 | spoiltforchoice
You can buy an awful lot of stencils for $200K > but where/how are you going to store all of those > stencils? There is a certain $$$ value to all > the space it will take to store them. > > I have > been told by a Mycronic salesman that they a
Electronics Forum | Fri Oct 19 13:57:17 EDT 2007 | Michael Konrad
Hi Rob, I must take issue with your statement �By definition, no clean solder can be not-cleaned�. All no-clean fluxes can be cleaned. Whether or not one cleans no-clean depends on a variety of factors. More than eighty percent of all post reflow
Electronics Forum | Tue Jul 28 17:23:58 EDT 1998 | Robert Steltman
| | We are about to run our first BGA devices and would appreciate some confirmation on a few points. | | First some details: | | PCB & Device: | | ============= | | 1) 16 layer (4 power, 4 gnd, 8 signal) | | 2) gold on nickel finish | | 3) ceramic