Electronics Forum | Sat Jan 16 03:06:36 EST 1999 | Wirat S.
| | Our spec on voids is 30% ball diameter in the center. On the component to ball and pad to ball interface, we use 25%. To determine this spec, we asked around. I don't know of any studies that have been done to verify if this is OK | | | | Regard
Electronics Forum | Thu May 09 11:59:34 EDT 2002 | russ
One thing I have done in the past although it may not be feasable in your case, is to process through normal reflow and then saturate parts with a high solids water soluble flux and re-reflow with hot air, iron, or even another pass through the oven.
Electronics Forum | Thu May 09 12:00:32 EDT 2002 | russ
One thing I have done in the past although it may not be feasable in your case, is to process through normal reflow and then saturate parts with a high solids water soluble flux and re-reflow with hot air, iron, or even another pass through the oven.
Electronics Forum | Fri Apr 06 12:31:07 EDT 2018 | deanm
Your fluxes are required to be compatible per J-STD-001. I wouldn't even attempt mixing no-clean (rosin) and clean (assuming water soluble) fluxes on the same assembly, especially if the fluxes are from two different vendors. If your paste and liquid
Electronics Forum | Tue Jan 14 19:41:32 EST 2020 | avillaro2020
Hi Evtimov, Thanks for your response. Yes, the vapour phase is suppose to handle big and heavy boards, at least thats the intention. Well our thin board is like around 3mm which is not really thin. In our application the thicker the boards means more
Electronics Forum | Mon Jun 13 09:23:54 EDT 2005 | russ
I agree with Dave on the Water soluble process for this part. It is interesting that I have yet to find a Water Soluble for lead free that works. I have experienced a lot of problems with the flux on these pastes, wetting, solder balls, etc... kind
Electronics Forum | Wed Aug 21 13:28:20 EDT 2019 | ameenullakhan
And what is the solder paste selection recommendation for the same. 1. Water soluble ( organic based flux solder based ) 2. No clean ( rosin or resin based solder paste ) customer is suggesting water soluble chemistry , which is having lot hot an
Electronics Forum | Thu Jun 26 13:55:56 EDT 2008 | dyoungquist
Water will not remove no clean flux residues because they are not water soluble. Solder paste with no clean flux should only be used when the assemblies do not need to be cleaned. That said, you can buy special cleaning solvents specifically for re
Electronics Forum | Tue Feb 06 23:01:44 EST 2007 | Wayne
The QFN is found to have contact problem during FCT. The paste that I am currently using is SnPb 63/37 water soluble paste. Is it because of water soluble paste? (unable to clean after reflow process as QFN is entrapped by paste/flux) Should we use
Electronics Forum | Mon Oct 31 17:01:54 EDT 2011 | kahrpr
What kind of flux/solder paste are you using water soluble or no clean
