Electronics Forum | Sat Jun 05 07:37:25 EDT 1999 | Dave F
| We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | John: Never heard of an "SOAC." SO packages are 50 ptch (50 mil, 1
Electronics Forum | Mon Jun 07 09:28:56 EDT 1999 | John Martell
Thanks a lot,, so assuming we are using standard parts, with nothing out of the ordinary we could safely assume that a machine capable of 20 mil would be more than able to meet our needs down the road. | We are changing from through-hole to SMT, won
Electronics Forum | Mon Jun 07 20:12:42 EDT 1999 | John Martell
Thanks for the advice, I'll check out that site. | | | We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | | | | | | | |
Electronics Forum | Mon Jun 07 13:51:48 EDT 1999 | Dave F
| | We are changing from through-hole to SMT, wondering what pitch requirements would an 8 pin SOAC require for pick and place? We think that this would be our finest pitch part. | | | | | | | John: Never heard of an "SOAC." SO packages are 50
Electronics Forum | Sat Oct 07 11:14:39 EDT 2000 | Aaron
1. It is hard to tell, but your PCB vendor should test the PCB. 2. I think the important thing is the width of the apertures. You should have it laser-cut, and control the width no more than 90% of half pitch. Good luck.
Electronics Forum | Tue Sep 30 14:06:04 EDT 2008 | realchunks
What pitch? You can go 5 mil or even 6 mil stencils depending on your screen printer. Also what do you consider "less solder"? What defect are you having. Remember on a QFP you use the heel filet to determine proper solder joint - not the toe.
Electronics Forum | Sat Oct 07 16:31:56 EDT 2000 | Elfego
Tray the electroform stencil.
Electronics Forum | Thu Oct 02 08:26:41 EDT 2008 | rway
We had similar issues until we went to a 6 mil stencil thickness.
Electronics Forum | Mon Sep 29 14:47:15 EDT 2008 | davef
Let's narrow this down. Questions are: * Are you putting the proper amount of solder in the board with your stencil print process? * If you are putting the proper amount of solder in the board, where is the solder going? Pick one and then fill-in th
Electronics Forum | Sat Oct 07 04:02:50 EDT 2000 | C.J. Long
Good morning, All: I am from PCB shop and one of our customer is experiencing solder bridge on 16 mil pitch QFP( immersion gold finish). Land width requirement is 8 +/- 1 mil measured over top of of land and our mean is 7 mil. Bottom land width is 8