Electronics Forum | Tue Dec 31 02:13:14 EST 2019 | agoesfirmanto
This PCB model has been in production since 2018 and stopped production almost 1 year ago, now it has started production again and I found this problem. at the time of production in 2018 this problem did not occur. while the parameter settings do not
Electronics Forum | Thu Jan 09 20:52:02 EST 2020 | Mike Konrad
If the world was a perfect place, I would recommend preventing solder balls in the first place. While low amounts of solder balls are common, a high volume of solder balls are problematic to a cleaning machine (batch or inline). Solder balls may beco
Electronics Forum | Wed Dec 09 09:47:32 EST 2009 | dyoungquist
I am curious as to why you need to mix.... We use a 500g cartridge with air gun. Our process is remove the cartridge from the fridge, allow it to warm up to room temperature before inserting into air gun, then apply bead of paste to the stencil. N
Electronics Forum | Mon Dec 30 23:37:47 EST 2019 | agoesfirmanto
Hello All, I am a SMT Engineer from Indonesia, I am facing the problem of soldering balls in only one IC location, in other areas there are none. solder ball defect almost 30%. I have done several actions but failed to reduce the solder ball. 1.
Electronics Forum | Thu Aug 24 15:37:50 EDT 2006 | Chunks
Hi Any, This is from an earlies thread "Solder Ball After Reflow Process". Date: August 16, 2006 01:52 PM Author: Russ Subject: Solder Ball After Reflow Process Oven settings are meaningless here. What does the board see? It is the paste we a
Electronics Forum | Fri Jul 06 03:23:01 EDT 2001 | kennyhktan
Hi there Steven ! Please allow me to share some of my problem we're facing here with you. Here are a few points that I suggest you should check on your current process:- (1)PCB - Component land partern design ? It is per IPC spec ? - Mask
Electronics Forum | Thu Jun 21 22:04:18 EDT 2001 | davef
This is my attempt at beating the "Fuzzburg 7" translator used on the SMTnet Forum that mashes everything it sees. Below the next paragraph are three paragraphs,each with a common numering sequence, where each paragraph represents the columns of a t
Electronics Forum | Sat Feb 02 08:36:22 EST 2008 | davef
As a minimum, we clean the printer setup every shift change. Probably the best advice on this is from your paste supplier.
Electronics Forum | Sat Oct 20 14:18:49 EDT 2012 | davef
I've been in shops with a flux containment pan under the wave fluxer. While I'd rather see excess flux in a containment pan than on the floor, but I'd prefer to see flux applied precisely to eliminate the need for either using a containment pan or cl
Electronics Forum | Thu Apr 17 16:43:09 EDT 2003 | davef
Background: * Bulwith, Ronald A., �Failure Analysis of Solder Joints�, �Insulation/Circuits� magazine, February 1978 * Banks, Donald R., et al., �The Effects of Solder Joint Voiding on Plastic Ball Grid Array Reliability�, Proceedings of the Technica
.gif)
