Electronics Forum | Mon Jul 14 22:40:45 EDT 2008 | edmaya33
hello Dave, thanks for the references. i will try to compare the results in 3 months interval.
Electronics Forum | Mon Jul 14 07:49:50 EDT 2008 | edmaya33
Do we really need to follow the IPC J-STD-001 Solder purity? If so, how to effectively balance the chemistry of Sn63/Pb37 other than adding a pure tin on the solder bath? Is this really needed to monitor in monthly basis?How many kgs of pure tin pe
Electronics Forum | Mon Jul 14 09:41:35 EDT 2008 | davef
Q1. Do we really need to follow the IPC J-STD-001 Solder purity? A1. Yes, you should control impurities in solder. Further information: * "Allowable concentration of contaminating elements in solder: impurities are harmless unless their level goes to
Electronics Forum | Tue Jul 04 19:37:05 EDT 2006 | two cents
100 PPM or 99.99% purity is sufficient for any soldering application. There are a number of manufacturers that make PSA style nitrogen generators that are great systems for electronics applications. They are low maintenance and will pay for themselve
Electronics Forum | Thu Jun 29 10:45:46 EDT 2006 | stepheniii
We have an ERSA Versaflow Ecoselect selective wave soldering machine. It works well except it needs nitrogen. You can't even move the table around if your nitrogen tank is empty. The spec sheet says Required degree of purity: Nitrogen liquid 5.0
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Tue Aug 25 20:06:12 EDT 2020 | ldavis
Yes, this consumption rate is normal for a high purity N2 process. We switched to a generator and had a payback of about 7 months. The bigger improvement than cost reduction though was in process consistency. When we were switching bottles we were
