Electronics Forum | Sat Jun 07 04:01:56 EDT 2008 | carmanah
Hi all, Need advice how to fix RJ45 short issue after wave solder m/c .Few actions taken to resolve this issue but the outcome was inclusive which was 1. Modify wave pallet 2. Change conveyor setting from 0.8meter/minute to 0.7 meter/minute 3. Clear
Electronics Forum | Thu Aug 30 20:35:51 EDT 2012 | davef
A common bottomside heater configuration is IR-Convection-Convection. One of the big advantages of the IR zone is its ability to allow the flux carrier to spread and dry slowly before the board reaches the convections zones, which can blow wet flux c
Electronics Forum | Fri Jul 09 06:51:46 EDT 2010 | cobar
Try titanium edge stiffners on the PCB before making solder pallets.
Electronics Forum | Fri Jan 28 05:06:01 EST 2000 | Istv�n Dominik
Hi! I have problems with the SMD boards during wave soldering. Mainly between the pins of the SOICs there are small solder balls. Maybe somebody had the same problem and could solve it. Please give me some ideas what causes this problem and how it
Electronics Forum | Tue Aug 10 03:42:04 EDT 2010 | aungthura
is it usual if the board has warpage on both sides after wave soldering? And, if it is, please advise me how to solve it. Thanks in advance.
Electronics Forum | Fri Jun 25 22:30:47 EDT 2010 | smthexi
i think you need to use a PCB central support. do you know that part ? it specializes in preventing PCB board from bowing during wave soldering.
Electronics Forum | Thu Jul 01 11:48:10 EDT 2010 | mb_mfg
Sid, Try baking the boards before running, to insure no moisture. Baking out the moisture will help prevent warping. Should you need further assistance, we supply fixtures to force the board to stay flat to reduce to thermo shock during wave solde
Electronics Forum | Thu Jun 24 15:33:56 EDT 2010 | davef
Our best suggestion - get the copper balanced and if possible go to higher Tg materials.
Electronics Forum | Fri Jun 18 17:36:10 EDT 2010 | sid
Good afternoon all, I have been trying to find a solution to a defect I just noticed. After stencil printing and smt part placement on the secondary side of my boards, I run them through a wave soldering system. All my components got soldered perfe
Electronics Forum | Tue Jul 06 05:00:33 EDT 2010 | smthexi
Hello Sid: i don't know where you bought the machine. the central support system is an addition part, it is specially designed to prevent the PCB board from bowing. i know that the wave soldering machine which made before did not include this useful
