Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Wed May 27 11:54:29 EDT 2009 | allwave
Armando, Make sure chip wave is pumping evenly across. These TD machines require a lot of maintenance (deep cleaning)to ensure all the holes on nozzle are open... My two cents, George
Electronics Forum | Mon May 25 21:10:28 EDT 2009 | padawanlinuxero
Hello !! I have a problem with my wave solder oven, in one of the products we made has connectors on one side of the pcb and in the other one has SMT components the process is kinda tricky on the SMT components we use an adhesive and put to the refl
Electronics Forum | Wed May 27 07:53:41 EDT 2009 | padawanlinuxero
Thanks ! I will try your recommendations, about the flux and the preheaters, yes they seems to be ok I will bring down de conveyor speed because it looks like if it is to fast is set to 3.6ft thanks again!
Electronics Forum | Wed Jan 12 21:37:04 EST 2005 | KEN
How thick is this pallet? 6mm, 8mm, 10mm? I would look at: Make sure you're pot height is correct (lead clearance). If you are burrying the pallet in the fountain, your going to "push" a large volume away. The solder "push" should not plow over t
Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
Electronics Forum | Wed Jul 29 07:26:12 EDT 2009 | dilogic
Hi Patrick, thanks for the response. I might add some more information - we succesfully soldered some boards with the same settings of belt speed, pre-heat temp. etc. This batch of boards differs from the previous in a way that they are 4-layer. May
Electronics Forum | Mon Nov 11 11:42:26 EST 2002 | MikeF
Like Mark, I'm guessing your problem is with SMT parts on the top side, the solder is re-melting and some of the parts are moving around during when the board is being wave soldered. When I had some training on thru hole wave soldering way back when
Electronics Forum | Mon May 07 12:11:33 EDT 2007 | colormaker
I have the option of increasing the wave pump but when I do the wave is very unstable. Do you have the possibility to create a backflow at the wave to drain the oxides away from the board? Not sure how to do this I wish I have the old 1962 7' holl
