Electronics Forum | Wed May 13 03:22:26 EDT 2009 | J.Hall
We use SAC387 (or 96SC) and I found that the SelectX was only marginally effective and that other factors (varying the wave height mainly - we use pallets) affected bridging more. Also, because we run different products at the same time through the
Electronics Forum | Tue Sep 21 09:33:30 EDT 1999 | Scott Davies
| | | My stencil thickness is 6 mil and we got qfp's with fine pitch. | | | how many percent should i reduce my stencil aperture using a 6 mil stencil for 0.5 mm pitch and 0.4 mm pitch ? | | | | | | thanks | | | | | We use 6 mil lasercut stencils w
Electronics Forum | Thu Aug 26 04:35:54 EDT 1999 | Wolfgang Busko
| | | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products.
Electronics Forum | Thu Aug 05 11:51:44 EDT 1999 | Wolfgang Busko
| | | | | | | | | | | | Hello, | | | If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem with chi
Electronics Forum | Mon Jun 28 21:07:00 EDT 1999 | Deon Nungaray
| Hey there gang, how's it going ? | | Anyway's here's my probelm, got a new product to build double sided reflow, lot's of so20's and PLcc's 1206's, 0805's the usual stuff. Probelm is all the pad spacing of the 1206's are too big, my component's ar
Electronics Forum | Mon Apr 05 08:25:31 EDT 1999 | ADRIANO FERNANDES
| | | I require some feed back from any one who knows about using a voc free flux in a nitrogen wave solder machine soldering both through hle and smt componants. | | | What disadvantages are there when using this flux? | | | Do you have any contact
Electronics Forum | Mon Nov 02 17:45:46 EST 1998 | ChrisK
In my experience, solder balls are normally caused by only a few things. In order of likelyhood: 1) Water based fluxes (VOC-Free)not having the water carrier completely dried from the board before going into the solder. I.E, too fast conveyor spee
Electronics Forum | Fri Oct 02 01:21:08 EDT 1998 | Mike Cox
Kyung Sam, | | Justin is correct, there is definately either a board design problem or the PCB maker issue. Obviously there are many mixed technology boards built in the world so I would lean towards a design issue as the root cause. Should you or
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Electronics Forum | Wed May 27 14:35:52 EDT 1998 | Justin Medernach
| | R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recomm
