Electronics Forum | Thu Apr 21 11:49:24 EDT 2005 | russ
Definitely would help when doing the search's. I always find a numerous amount of suggestions but you're right, you never know if anything worked! Russ
Electronics Forum | Thu Apr 21 12:39:10 EDT 2005 | patrickbruneel
Thanks Russ I must have caught you on a good day I'm not used to see you agree with me. Just kidding (couldn't resist)
Electronics Forum | Fri Apr 15 13:46:50 EDT 2005 | steve
They can be expensive and if your using water soluble chemistry you will have to immerse the pre-form into flux. Asking the vendor to provide flux with the pre-form I believe it would dry out prior to use.
Electronics Forum | Fri Apr 15 16:14:49 EDT 2005 | davef
Jim Zanolli of Teka Interconnect did an "OnBoard Forum" a couple of years ago [ http://www.smtnet.com/forums/index.cfm?CFApp=2&forum_idx=44 ]. He certainly would be a good point of contact.
Electronics Forum | Tue Apr 19 09:09:28 EDT 2005 | russ
Here is one reason- It eliminates the viscosity change during printing operation from the paste warming up and getting thinner. I would contact your paste supplier and have them give you the full list.
Electronics Forum | Fri Apr 22 19:43:01 EDT 2005 | steve
And don't re-refrigerate the paste. It's fine left out at room temperature and sealed. If you want to know why simply ask and the next 8 respondants will tell you.
Electronics Forum | Mon Apr 25 07:31:35 EDT 2005 | jdengler
As Steve said do not re-refrigerate. You can also take the paste out early. We remove enough paste from the refrigerator for a full days work around noon the day before we use it. Jerry
Electronics Forum | Thu Apr 21 08:45:53 EDT 2005 | davef
Top 10 products relating to solder paste are: * Printer * Stencil * Stencil storage rack * Squeegee * Squeegee holder * Under stencil wipe * Under stencil cleaning fluid * Stencil cleaner * Dispenser * Paste stirrer * Used paste / empty paste contain
Electronics Forum | Fri Apr 22 11:27:01 EDT 2005 | ddennison
Go to the following web site: http://www.pro-mation-inc.com/ Contact: Gary Goldberg at 847-812-1289 if you have any questions!
Electronics Forum | Thu Apr 21 14:06:28 EDT 2005 | russ
Dang Patrick, I'm going to have to agree with you again. The design needs to be corrected. This multiple footprint is a common thing nowadays but the designers need to understand the dynamics of reflow and such. PWH - Why would this mask need to
winsouce.jpg)
.gif)
