Electronics Forum | Thu Feb 15 21:59:09 EST 2007 | vshan
Hi Jim Good Day yes we are using a pallet bottom support as well as top cover. The top cover are design such a way that the solder paste area is open. the type of solder is lead free type(Avantec-ecorel free) in one panel consists of 28 parts and e
Electronics Forum | Thu Feb 15 08:34:50 EST 2007 | rgduval
Jim, In a previous life, we built some flex circuits for a customer. The configuration was a flex cable, with a circuit at one end of it. We had fixtures made out of the same material that we had selective wave solder fixtures made from. Cut an i
Electronics Forum | Thu Feb 15 20:27:11 EST 2007 | vshan
Hi Chris Good Day!!!! well we are running flex panel(150x270) with one connector(3 pin legs both sides) insert. Each panel consists of 28 parts and its used for disk drive industries. We are having a pallet to support with the top cover design such
Electronics Forum | Wed May 16 15:40:56 EDT 2012 | davef
Here's some notes from a Bob Willis presentation Assembly of Flexible Circuits with Lead-Free Solder Alloy [Bob Willis leadfreesoldering.com] * Flexible Circuit Construction ** Base Material - 0.05mm Copper 18/18 um ESPANEX from Holders Technologies
Electronics Forum | Wed Dec 08 12:48:01 EST 1999 | Chuck C.
Is anyone out there having problems with noise in analog circuits caused by the residue that no-clean solder paste leaves after reflow? If so do you have any suggestions on how to eliminate the problem??
Electronics Forum | Mon May 21 11:14:06 EDT 2012 | joeherz
Polymide is like a sponge and absorbs moisture much faster than rigid substrates. Pre-bake your substrate for 2-4 hours at 125C and perform your soldering within 1 shift thereafter or seal in moisture barrier bags.
Electronics Forum | Wed May 16 11:19:08 EDT 2012 | fulgen
Hi Guys, I´m looking for information about processing smt components on flexible printed circuits (printing, SMD assembly,reflow soldering and laser cuting). These flexible circuits comes from a roll of 300 mm width. I found some information about ro
Electronics Forum | Fri Jun 09 10:01:39 EDT 2017 | jkitt84
Ed, this is great info. Thanks. Jeff
Electronics Forum | Thu Jun 08 11:37:44 EDT 2017 | jkitt84
davef, thanks for feedback. I talked with a plater who said they put copper before silver when plating brass. Would a complete stack of: Brass part, then 0.0001-0.0002" of copper, then 0.0005" of silver, then Tarniban anti oxidation. Sound reasonabl
Electronics Forum | Thu Jun 08 07:56:34 EDT 2017 | jkitt84
In an excellent previous thread davef mentions brass should be plated prior to soldering to prevent zinc leaching from the brass. It is reported once the zinc leaches, the joint is weak. He recommends copper or nickel plating. Would silver plating w
Hitechpcba is a wоrld-lеаding PCB Manufacturing & PCB Assembly company with more than 20 years experience in the electronics manufacturing industry. We focus on Circuit board fabrication, PCB assembly, electronic parts sourcing.
3F, B5 Dong, Zhimeihuizhi, FuYong, Bao'an Dist.
Shenzhen, China
Phone: 008675529630063
