Electronics Forum | Fri Oct 23 09:29:29 EDT 1998 | Allen
We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good but
Electronics Forum | Fri Oct 23 14:58:40 EDT 1998 | Dave F
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Wed Feb 01 12:20:16 EST 2006 | cvoyles
Hi Bruno, I am an equipment reseller in business since 1994. I have a Smart Sonic MG3000 ultra sonic stencil cleaner in inventory. It is a stainless steel model with Delta Sonics brand ultra sonic generator. It is the guillotine type that raises a
Electronics Forum | Fri Oct 23 09:44:43 EDT 1998 | Chrys
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Thu Sep 26 14:03:55 EDT 2002 | Randy V
There are allot of issue to washing that need to be considered before you purchase a washer. But to answer your question regarding ultrasonic cleaning: 1. Ultrasonics with the correct frequency will not damage most components. Washing in general can
Electronics Forum | Fri Oct 23 15:44:57 EDT 1998 | Mike
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Thu Jan 23 20:57:33 EST 2003 | davef
If the flux was not activated (ran in another area of the board), the flux should be removed from the board. Any Comments? A: We agree. In order for its �benigness� to take effect, NC flux is affected by: * Type of flux * Amount of flux * Proper ac
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Mon Aug 17 02:50:44 EDT 1998 | Bob Willis
| Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple
| 1 |
.gif)
