Electronics Forum | Fri Jan 29 11:23:54 EST 2010 | ppwlee
Smtnet, I am looking at pros and cons for automated soldering. The application is a simple multi pin through-hole soldering on a high volume manual assembly line. The goal was to eliminate defects associated with missing solder pins which goes undet
Electronics Forum | Thu Oct 10 17:32:52 EDT 2013 | soscomputer
you're right for sure, but there is some brand like hakko i don't like them why ? because process and menus (controllers) doesn't really give a good result. For example fm206, hot air/desoldering/soldering station doesn't have the real tc. And a lot
Electronics Forum | Wed Nov 17 15:04:27 EST 2004 | russ
SMT assembly, First, you must utilize paste otherwise the parts will not stay put. Do you have any leaded devices such as QFPs or SOICs? Dispensing paste by hand is very difficult and time consuming for these types of parts. You can either dispense
Electronics Forum | Wed Feb 06 06:32:06 EST 2013 | bandjwet
We have been running both SRT and APR rework systems for many years in our business as a service provider of BGA rework (http://www.solder.net/services/bga-rework-services The SRT is a true workhorse with good bottom side heating capabilities. If yo
Electronics Forum | Mon Mar 31 13:51:33 EDT 2008 | gregorys
Hi! May be somebody help me with links to materials or document`s for assign separate (separate room) installation of cleaning equipment from all another SMT line. p.s. some managers of my company want to install solvent based cleaning units in same
Electronics Forum | Wed Nov 17 09:51:25 EST 2004 | AS
I'm looking for advise on setting up a prototype station for smt (we are currently outsourcing smt production, but have a need for rapid in house prototyping). The station must be able to handle only single sided boards with components no smaller th
Electronics Forum | Mon Dec 29 09:37:25 EST 1997 | Craig Wilmer
| Can anybody give me feed back on the pro and cons of | using Pace, OK, Hakko, Metcal, etc... Kris, Pace is going to be your best bet when it comes to productivity. I used to do rework and repair for Compaq and all of the PCA lines in their manufa
Electronics Forum | Tue Jun 15 15:57:00 EDT 2004 | russ
I have used one in the past and wish I had one now. Is that enough input? We had great success with this machine. The large lower preheat and board supports worked very well for large thin boards. We never experienced any problems with this machi
Electronics Forum | Thu May 01 17:38:06 EDT 2008 | ldbepurchase
www.ldbepurchase.com
Electronics Forum | Mon May 21 19:32:36 EDT 2007 | jimpat
Jeremy, Just started looking into this equipment myself. I have not dealt with Madell Tech however, I know that they do not manufacture equipment . . . they are importers / resellers of equipment made in China. To me the stuff on their site does n
winsouce.jpg)
