Electronics Forum | Sun Oct 01 23:58:55 EDT 2000 | stuartfd
Dear forum types, 1st timer so be good. I have a customer in China using Coates soldermask that in its self is not a problem. The problem is the flux their using, I think,it appears to have a vary high viscosity. The problem they have laid at my door
Electronics Forum | Fri Oct 15 10:23:48 EDT 2004 | mrmaint
Matt, are there any discoloration of the pads on the raw boards. i have seen what we refer to as gray pads. Ran into this in the past and it turned out to be a problem at the board house with one of their dipping tanks. The proper levels for the proc
Electronics Forum | Thu Aug 20 09:47:46 EDT 1998 | Dave F
| Will somebody please explain HASL (here). Thanks. Tryin: HASL: Hot Air Solder Leveled. A board fabrication process that applies an oxidation preventing solder coating to copper pads on the board. Dave F
Electronics Forum | Fri Aug 21 07:57:20 EDT 1998 | Earl Moon
| | | Will somebody please explain HASL (here). Thanks. | | Tryin: HASL: Hot Air Solder Leveled. A board fabrication process that applies an oxidation preventing solder coating to copper pads on the board. Dave F | You do this to keep the green s
Electronics Forum | Thu Jun 29 07:48:59 EDT 2000 | Mark
Welcome Bob, HASL stands for "Hot Air Solder Level" and is the final finish the raw boards guys place on the solder pads on the PCB. There are two popular raw board finishes, HASL which is a solder finish and NiAu which is Nickle Gold, and is a Gol
Electronics Forum | Fri Feb 28 08:48:00 EST 2020 | SMTA-Joe
We've made the decision to move towards Gold Immersion on our PCBs to eliminate flatness issues with QFNs and BGAs. Land/component pad geometry, population density, and other factors, have made it necessary to ensure a near perfectly flat surface tha
Electronics Forum | Mon Apr 19 15:45:21 EDT 2010 | dwonch
Thanks to all for your input. We did have a third party do an analysis on boards from the first shop. They were shipped directly from the board shop to eliminate the possibility that we could contaminate them. The third party (Forsite) did find Sili
Electronics Forum | Wed May 19 13:13:20 EDT 1999 | Dave F
| We care currently running into problems during our plug via process: | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.This is
Electronics Forum | Fri Aug 21 07:38:34 EDT 1998 | Tryin'
| | Will somebody please explain HASL (here). Thanks. | Tryin: HASL: Hot Air Solder Leveled. A board fabrication process that applies an oxidation preventing solder coating to copper pads on the board. Dave F You do this to keep the green stuff (
Electronics Forum | Thu Oct 05 15:58:16 EDT 2006 | RusH
Mario, Thanks for your response. We are building a leaded assembly with hot air leveled Sn/Pb pads on the PCB. In one case the component is a 7.5X5.2X1.8 wire wound ferrite inductor with Au/Sn leads. The second component is an 0808 Tantalum cap,
winsouce.jpg)
.gif)
