Electronics Forum | Thu Sep 13 11:01:39 EDT 2007 | cyber_wolf
Fuji specs out Omega 66 grease for the solenoid sliders on older CP machines. These solenoids run hot. Its interesting to me that this grease is designed for extremely low temperature applications. Whats up with that ? http://www.omegaoil.co.jp/ind
Electronics Forum | Wed May 26 11:16:03 EDT 2010 | cyber_wolf
It is totally normal for these solenoids to run very hot. Hot enough to fry spit. I wouldnt pay any attention to it
Electronics Forum | Tue Nov 04 07:38:51 EST 2008 | jdengler
SrTech, I do not know Mydata's but I had a problem with a solenoid for a nozzle changer that just didn't seem to be strong enough. Finally found a partial break in the wire. I seemed like this acted a resistance to the current flow and did not all
Electronics Forum | Wed Jun 16 22:19:11 EDT 2021 | SMTA-64387687
Check the solenoids. They may not engage properly.
Electronics Forum | Thu Oct 06 18:30:13 EDT 2022 | kojotssss
Solenoids, air flow sensors was checked?
Electronics Forum | Wed May 26 04:46:13 EDT 2010 | mmjm_1099
ALl - I need some feedback why a solenoid on station 3 is getting excessively hot. I have another line with the same setup but is not getting as hot. I have tested out voltage and see nothing that is triggering me there is an overvoltage. Any feedbac
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Mon Oct 02 13:46:53 EDT 2023 | SMTA-72837649
If it's the same as the 32D, 2 things need to happen. Air pressure at the nozzle for atomization, and the solenoid at the bottom of the flux tank needs to open to provide a gravity stream of flux. You should be able to take both hoses off and check f
Electronics Forum | Mon Sep 02 15:41:47 EDT 2013 | aemery
Mr Duckmann2000. Where is the leak??? Is it up on the dispenser behind the printhead? If so the simpliest thing to do, assuming you are not using the dispenser, is to cut the incoiming air tubing to the dispense pinch, fold it over and ty-wrap it.
Electronics Forum | Fri May 14 15:28:39 EDT 2010 | timryder
I have an application I'm trying to solve which would allow me to vary voltage going to an Electric Solenoid at 24v ~3.0amps DC. What I want to do is create a device to vary the voltage going to the Solenoid using a pulsed digital input. I have a mot
