Electronics Forum | Thu Apr 16 13:16:05 EDT 2009 | jeffharley
You might try checking to see if the float switches are actually lifting up with the water level, I have seen them get stuck in the open position. Also check to see that the solenoid valve is actually sealing off (closed)
Electronics Forum | Fri Jul 31 17:09:55 EDT 2009 | isd_jwendell
Don't know about Topaz, but on Essemtec machine using SMC ejector, there are separate solenoid valves for vacuum and release. The connectors are identical and side by side. If these connectors were swapped then I would have the symptoms you describe.
Electronics Forum | Wed Nov 04 21:18:23 EST 2009 | isd_jwendell
I only have first-hand experience with 2 pick-n-place machines, but both used a small pressure puff to insure part release. I haven't seen any software settings for this, but a small solenoid valve was dedicated to the operation. I recommend you look
Electronics Forum | Wed Mar 27 16:03:01 EDT 2019 | jdengler
Jim, It's been a long time since I worked on one of these so this is going to be a general idea as to the issue. There's a solenoid valve that is controlled by the E-stop ckt. When in E-stop in stops air from entering and vents the pressure lines
Electronics Forum | Tue Nov 01 09:24:06 EST 2005 | UIC HSP Techs
The problem you report is very uncommon. Nozzles falling out of the placement heads can only be caused by severe mis-adjustment or failed parts. The following items should be checked: 1) Nozzle position hooks (on placement heads) 2) Clutch solenoid/
Electronics Forum | Thu Jun 14 16:52:08 EDT 2007 | joeherz
Brian, We've see foaming issues with our wave flux occasionally when running large slugs of product through the wash. We love the wave flux and changing it was not an option. Our process parameters for the wash machine we're derived via a validati
Electronics Forum | Thu Sep 13 14:18:59 EDT 2007 | slthomas
Just a little status update. When it's running and I monitor the I/O, the mount vacuum bit never turns over to 0. It may be turning over enough to run, but not long enough to see on screen. It stays at 1. When it errors, I can trip it by putting my
Electronics Forum | Wed Mar 13 11:03:59 EDT 2013 | marcelorotofrance
Despite this machine is an obsolete dynosaur, almost 1/4 century old, is (was) a reliable work horse. Now is broken. Just after first reset the screen shows an error message "1420 XY INTERLOCK". The message clears with RESET. When I push ORG button
Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, 09 Malaysia
Phone: 6043809899
