Electronics Forum | Fri Feb 04 09:48:12 EST 2005 | russ
Try Petlock enterprises www.petlock.com
Electronics Forum | Fri Feb 04 09:17:30 EST 2005 | Steve Gregory
I have a need for two heater element/strips for the pot of a Econopak EPK+ Type 400F. PN 3-0606-793-01-2. I was told it would be 2-3 weeks from Electrovert. If anybody knows of where I might get them quicker than 2-3 weeks, I sure would appreciate it
Electronics Forum | Wed Jan 13 09:32:56 EST 2016 | mario
Hi everyone, I am looking for a distributor for the Folungwin wave machines, we need to buy solder pot heaters part number FL-MD-E-LD-FRG-01 and our canadian distributor only has a few units to sell and the leadtime seems to be around 4 weeks, meanwh
Electronics Forum | Tue Feb 08 07:11:24 EST 2005 | teilo
We manufacture all titanium component parts for wave solder machines. For additional information on our products please visit our websit at http://www.teiloengineering.com
Electronics Forum | Thu Jan 14 10:59:00 EST 2016 | davef
Don't forget to post your equipment "wants" in the SMTnet Equipment Mart http://www.smtnet.com/parts/ ... ... used equipment-types are more likely to look there than the Forum
Electronics Forum | Tue Mar 14 20:42:24 EDT 2023 | stephendo
In a previous lifetime, we had a selective solder machine where I would see solder splashes in the roof of it. I thought someone might have been putting the solder extremely high. But when it was melting there would be bubbles that burst. The manufac
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Fri Sep 20 08:34:30 EDT 2013 | island2013
We've done the same as what Woodsmt has suggested. Bread pans and a ladle. Slow going but safe. We did not have to add anything to the pans to prevent sticking. Woodsmt, did you have to worry about the pot heaters over heating while draining?
Electronics Forum | Tue Jun 25 22:22:22 EDT 2019 | proy
We have an electrovert 16" econopak wave solder machine with two identical pots (exchange between Tin Lead and Lead Free). When the pots are exchanged the same thermocouple is used, and the same controller is used - with the set point adjusted. The S
Electronics Forum | Thu Aug 07 19:48:23 EDT 2003 | Shawn
We do allot of multi layer boards with heavy ground planes or heat sinks attached. We have a Trieber, use RMA flux, solder pot temp at 500F, foam fluxer, spray the top if need be, and would warm up the PWB to around 240F over the preheaters. We have
