Electronics Forum | Sat Jan 18 08:49:17 EST 2014 | emeto
The voltage is too high. I would check all the solid state relays.
Electronics Forum | Sat Mar 20 08:54:28 EST 2004 | Primus
As I said, I'm new, and I've never seen the adhesive dot method. I'm certian our company will stick with paste, though, because we make our own boards (with a vertical plater no less!!!) and contamination is quite an issue. We do a fair amount of rew
Electronics Forum | Sat Jun 07 00:21:50 EDT 2003 | kevyeoh
J-STD-020 Moisture/Reflow Sensitivity Classification for Non-Hermetic Solid State Surface Mount Devices. There's a profile for Lead Free and another for normal Sn/Pb.
Electronics Forum | Thu Jan 25 15:39:07 EST 2007 | electrovert
We swapped the solid state relay for zone 5 bottom to zone 5 top but the problem came up once a while. As for noise protection, there are jumpers at E1 to E8 and E9 to E16. They are hardware filters and prevent noise spikes from affecting thermocoupl
Electronics Forum | Wed Dec 17 08:43:14 EST 2008 | stiva
Have seen this problem on other types of oven and it was caused by failed solid state relays that energise the heaters.
Electronics Forum | Fri Apr 24 13:50:44 EDT 2015 | duchoang
Try to check the SSR (Solid State Relay) in the back panel. You may need to replace one or some of them. Good luck.
Electronics Forum | Tue Feb 07 20:49:31 EST 2017 | youngbuck
On a our electricity ovens the most common problem with overheating zones is usually the solid state relays.Not sure if this would relate to the Heller ovens.
Electronics Forum | Thu Mar 01 16:58:05 EST 2001 | davef
Last time we looked at this, JEDEC carefully designated the dimensions of the carriers, but "neglected" to define the component orientation with the carrier. Go to http://www.jedec.org/download/, search for JEP95 JEDEC REGISTERED AND STANDARD OUTL
Electronics Forum | Fri Jul 24 11:56:24 EDT 2009 | stepheniii
I've had the relay that controls closing the lid go bad It's a solid state relay if I remember correctly. Are you talking about a motor driven lid? edit now I"m trying to remember if that place had conceptronic ovens and that's what I"m thinking of
Electronics Forum | Sat Apr 25 11:37:56 EDT 2015 | ercdave1
DucHoang, thank you for your reply. as you mentioned I checked the solid state relays on the input and output side. I did get power coming out of all even when the conveyor was stopped. I will mark them with their position and swap some to see what h
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
.gif)
