Electronics Forum | Thu Dec 03 03:13:11 EST 2015 | polar121
Hi has anyone had a fault with a soltec deltawave model 6622cc were the following functions all turn off for no reason Preheat zone1 and 2 the fluxer and the solder wave pump this has been happening for the last couple of weeks and seems to be getti
Electronics Forum | Thu May 28 01:48:16 EDT 1998 | Roni Haviv
Hello, I need some users information about "hot air knife" after the wave bath: - Defects reduction ? - In what kind of boards(TH/SMT SOICS ect.) it is applied ? - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ?
Electronics Forum | Thu May 28 12:47:08 EDT 1998 | Dave F
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Thu May 28 09:23:59 EDT 1998 | Chrys
| Hello, | | I need some users information about "hot air knife" after the wave | bath: | - Defects reduction ? | - In what kind of boards(TH/SMT SOICS ect.) it is applied ? | - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ? |
Electronics Forum | Tue Aug 17 18:33:01 EDT 2004 | Hiram
Hi everybody, We are in the process of buying a new wave solder machine. Does anybody have experience working with Vitronics-Soltec (Delta wave 6622-CC for example)? What about Electrovert (Electra)? I would appreciate your feedback. Hiram
Electronics Forum | Mon Jun 12 09:07:10 EDT 2006 | JimC
Flux: Getting enough- is the spray fluxer getting good through-hole penetration. Try cranking it up. Soltec spray fluxers are not really as good as Ultrasonic Systems or Sonotek ultrasonics or the new ServoJET, but should do the job. Also, try anothe
Electronics Forum | Thu Sep 02 10:41:41 EDT 2004 | dj_jago
Other way around Dave. We decided that the Delta had more in common with the Electra rather than the Vectra, the Electra being much more expensive. For example, we wanted 3 preheat zones for lead free and this would mean an exernal fluxer unit if
Electronics Forum | Mon Jun 12 14:16:23 EDT 2006 | Kip the Expert at all Things SMT
Hi. I agree that the Soltec has weak, low-wattage preheaters, and also, the Soltec's fluxer is flippin' weak too. It doesn't do a good jab of atomizing the flux and getting good, huh-huh, penetration on the holes. I cranked up my Soltec's pressu
Electronics Forum | Mon Jun 12 09:08:17 EDT 2006 | Chunks
Hi Grant, Boy, how do I say this - I might have to agree with Wave Master Larry. (Yeah, yeah - I know; Davef and Dr. Shocker will "burn me" again) "We" also solder large thru-hole connectors on with a selective solder machine. They measure 4 by 8
Electronics Forum | Mon Jun 12 09:47:18 EDT 2006 | patrickbruneel
Hi Grant, You definitely have a pre-heat problem and not a flux problem. Pallets together with the BNC connectors put a large thermal demand on your pre-heating. 3 zones would be a good investment even with leaded solder due to the high thermal dema
