Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Thu Nov 15 13:50:03 EST 2007 | wavemasterlarry
I also consult in all matters wave related. i have a degree from Soltec college and am now a CWMT (Certified Wave Master Technocologis). WaveMAsterLarry@yahoo.com
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
Electronics Forum | Thu May 31 12:58:49 EDT 2007 | wavemasterlarry
Listen, why are you guys comparing air conditioning to wave soldering? There is no way your house will get that warm, unless it catches fire - I would know cause i smoke in bed way too much. Anyway, my two soltecs run 16 hours a day. on 3rd shift
Electronics Forum | Wed Dec 10 01:56:12 EST 2008 | lococost
The angle is a standard Soltec 7deg. We don't have the tools to measure this accuratly, but I do trust Soltec on this.
Electronics Forum | Thu May 18 03:36:38 EDT 2006 | Grant
Hi, We are about to change our wave over to lead free solder, and it's a Soltec Deltawave, which uses about 750 KG of solder. Our supplier is recommending we change the bath over, however that seems a bit extreme. They are concerned we won't get ri
Electronics Forum | Thu May 28 01:48:16 EDT 1998 | Roni Haviv
Hello, I need some users information about "hot air knife" after the wave bath: - Defects reduction ? - In what kind of boards(TH/SMT SOICS ect.) it is applied ? - Where can I purchase it as a retrofit (Soltec Delta 6622cc) ?
Electronics Forum | Thu Aug 28 08:31:55 EDT 2008 | grics
Sorry for the confusion... "WML" is a who... Wave Master Larry... He is a person on the forum who has a degree from Soltec? I don't remember... I was hoping he would have left a comment or some info that we could all learn by. (I am not sure how thi
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
winsouce.jpg)