Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto
So is the initial motor at fault failing now or the one from zone 3?
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
Electronics Forum | Wed Sep 16 09:04:12 EDT 2009 | stepheniii
All the heat that comes off the machine comes from powering the machine. The more heat that comes off it, the more energy that went into the machine. When the machine is cold there is no heat energy leaving the machine. Therefore complete cooldown
Electronics Forum | Wed Sep 16 09:29:47 EDT 2009 | patrickbruneel
There has been a thread on the subject in 2007 with record postings. Check here: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11796&#Message50533
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Thu Nov 15 13:50:03 EST 2007 | wavemasterlarry
I also consult in all matters wave related. i have a degree from Soltec college and am now a CWMT (Certified Wave Master Technocologis). WaveMAsterLarry@yahoo.com
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
Electronics Forum | Tue Jul 13 08:17:54 EDT 2010 | davef
We expect to find recommendations on periodic maintenance from the equipment fabricator in the operating manual. Those recommendations should be the basis for you to setup your maintenance program.
Electronics Forum | Sat Feb 15 15:39:53 EST 2003 | Joe
I have the identical machine and setup as you with the same issue(s). I looked at setting up for N2 but am choosing to retrofit to a standard lambda nozzle setup. If you are soldering bottom side SMT parts or other challenging assemblies, N2 may ma
