Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Fri Oct 12 14:53:40 EDT 2007 | chef
The only sophisticated customer I have is 100% ROHS and actually spec.s material and properties for the fab.'s. The rest have mostly just called in and requested we process ROHS without having to change the drawings or provide a spec. nary a complain
Electronics Forum | Wed Oct 17 11:52:15 EDT 2007 | stepheniii
I'm a > CM- high mix, low to medium volumes. No steady > all day every day runners- I am standardizing my > plant as ROHS only- the customers not requiring > lead free are getting an upgrade (MY humble > opinion - they are just too lazy to spec.
Electronics Forum | Wed Oct 10 14:21:04 EDT 2007 | petep
We have done the Green Framed Stencils for an added $50.00 per, then got smart and went to green polyester on RoHS / Lead Free Stencils at no added cost. Dedicated Stencil blades and holders green of course) as well as Green Static mats on dedicated
Electronics Forum | Thu Oct 11 14:56:27 EDT 2007 | chef
Thank you- my point exactly and it starts in SMT- operators pulling the wrong paste from the fridge, touch up using the wrong solder wire, etc. My solution- GET THE LEAD OUT!!!!! I'm a CM- high mix, low to medium volumes. No steady all day every day
Electronics Forum | Fri Oct 12 14:46:56 EDT 2007 | chef
All- good points and to be clear not all is in fun and jest. I support ROHS for the environmental issues. Get the lead out is my mantra, there's alot to consider for sure. I prefer to migrate that way, in time. Most my jobs are ROHS already, just a f
Electronics Forum | Tue Oct 16 13:29:03 EDT 2007 | cyber_wolf
Is anyone still making parts for these printers ?
Electronics Forum | Wed Oct 17 11:34:47 EDT 2007 | clampron
http://ateksystems.com/ This is the company that bought the rights to manufacture these printers so he might be able to get parts. Harvey Bower is the contact. Good Luck Chris
Electronics Forum | Wed Sep 19 09:20:05 EDT 2012 | georgert
When possible we put 2 images on a stencil to save money and storage space. I was told the DEK can not use offset images, Is this true?
Electronics Forum | Wed Sep 19 09:58:24 EDT 2012 | stivais
Probably depends on the model. We have DEK Horizon and we sometimes place 2 images on the same sheet (in the Y dimension. It's not possible for the X dimension). Just make sure that there's enough space for a paste roll and squeegees between the imag