Electronics Forum | Wed Apr 11 21:06:49 EDT 2018 | jacobidiego
Hi experts, I have some stencils in a bad state. Some of the marks belongs to squegee operation. I wonder if it is possible to measure the pressure that is being applied, as we can set the pressure, but we don't know if that value is real and calib
Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas
hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai
Electronics Forum | Wed Jan 11 06:29:47 EST 2012 | cbeneat
We have Vectorguard frames we've been using for about 6-8 months. We've seen no leakage on ours. The frame has written on it an operating pressure of 101.5-116.0 psi,our pressure is set a lot lower, 50-60 psi, as we also use another frame that can'
Electronics Forum | Tue May 15 12:56:51 EDT 2001 | Scott B
We had a similar problem a while back and found it to be an operator messing with the air pressure valve (of course no-one admitted to doing it). When cranked up enough, there was enough back pressure in the syringe to increase the volume of material
Electronics Forum | Wed Mar 11 16:43:20 EDT 2020 | sumote
There is a 8lb steel plate that is held down by 4 toggle bolts at the top of the machine. Its where you load the cutting media. If that plate does not have a pressure gauge built into it, contact CCR. They will send you one free of charge (at least t
Electronics Forum | Wed Mar 15 11:34:28 EDT 2023 | proceng1
I'm sure this isn't the same situation, but we did have a selective solder machine with crazy dross and solder ball build up. Turns out the operator switched the low pressure nitrogen line used for solder level and the high pressure nitrogen line fo
Electronics Forum | Tue Dec 19 20:54:52 EST 2006 | Guest
Your experience is quite different than mine. At continues dispensing,I noticed that glue dispense volume increase as the material in the syringe decrease. My machine is using air time pressure pump. This is normal for this kind of pump since ai
Electronics Forum | Fri Jun 15 09:59:29 EDT 2001 | brownsj
We have recently had an incident where we feel that we have received a batch of cards from our assembly house which have by-passed their ICT operation. This has been determined by the lack of any indentations on the test pads from the sprung probes.
Electronics Forum | Wed Jun 06 13:38:15 EDT 2001 | Michael Parker
To expand on Wolfgangs reply, I suggest you contact your local SRT rep. We recently had the same type of problem as yourself. This is the path we followed. Arrange for operator training, for yourself first, then the operators after you get the machi
Electronics Forum | Mon Dec 22 19:53:11 EST 2003 | Dean
Digital camera's are worth their weight in gold! Foremost it's a health and safety issue. That alone should compel the management team to get with the program. As an Engineer I have to know how to operate, program, maintain, troubleshoot and CLEAN
