Electronics Forum | Wed Apr 20 12:22:51 EDT 2005 | jdengler
Russ is correct, but you may have variations between board density types also. Some ovens may be able to handle low density boards with no spacing, but need a zone's worth of spacing for high density boards. Other ovens don't need any spacing for a
Electronics Forum | Mon Sep 17 10:11:26 EDT 2001 | jstarkweather
What is the tightest spacing that you have assembled 0201 components? Under what assembly scenarios did you produce the best/worst yield at this spacing?
Electronics Forum | Wed Apr 20 11:56:07 EDT 2005 | russ
Depends on the oven I have found, I had one oven that required about an entire zone for spacing while another I found that I could put them in back to back with minimal or no spacing.
Electronics Forum | Tue May 22 11:58:48 EDT 2012 | rway
Chris, > > If the short in the picture is parallel > to the wave turning the board 90Deg will solve > the issue. Because then the lagest spacing will > face the wave parallel and the smallest space > perpendicular. Yes, good point Patrick. H
Electronics Forum | Mon May 02 11:24:56 EDT 2022 | dontfeedphils
"Space saver frame takes same space as Vector Guard." I believe this is the case if you store the VG foil in a box, otherwise the VG should be thinner than the space saver.
Electronics Forum | Mon Feb 22 15:46:05 EST 1999 | Earl Moon
| Hello | Is there anyone who can give me some information regarding yield from gluing 0603 | Is there any other problems that you might have had. | | We glue bottom side 0603's but have changed our pad spacing to accomodate tolerance requirements
Electronics Forum | Wed Jul 06 13:22:25 EDT 2005 | Dreamsniper
Can anyone help me on where to find reference for the above info other than IPC2221 as it is not covered by the said standard. I am looking for a proper trace spacing for my lightning protection circuit on my PCB for the following requirements: 750
Electronics Forum | Wed Jul 06 13:22:48 EDT 2005 | Dreamsniper
Can anyone help me on where to find reference for the above info other than IPC2221 as it is not covered by the said standard. I am looking for a proper trace spacing for my lightning protection circuit on my PCB for the following requirements: 750
Electronics Forum | Tue Apr 01 19:45:07 EDT 2008 | boardhouse
Dave, Sorry for the slow response, have been out of town, The spacing I was referring to was from board edge to copper features. This spacing is required to keep the router and score blades from exposing or hitting the Copper. Regarding the slot I
Electronics Forum | Fri May 16 17:15:16 EDT 2014 | edwardt
Desire to push the spacing limit as usual. If I place two 0402 components spaced 7mils between the edge of the two components adjacent pads, which allows for 4mils solder mask webbing between component pads, what would the risk be? Potential for sold