Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Tue Mar 07 21:57:54 EST 2017 | ttheis
It was indeed the fact that the height sensor needle was moved away from the dispense needle. Happened to find a height probe rod with longer reach in the spare parts shipped with the machine; with the height sense probe next to the needle the machin
Electronics Forum | Wed Jul 22 17:05:01 EDT 1998 | Ben Salisbury
| Does anybody know of any specialty type machine shops that fabricate replacement parts for Surface Mount Equipment. I am looking for alternatives to buying replacement parts from the manufacturer. | Thanks, | Rob Rob, Alot of it depends on how spe
Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
Electronics Forum | Thu Jun 01 16:46:40 EDT 2023 | assuredtech
We have the following Samsung CP20 spare parts and feeders available, we also have CP40 - CP45 spare parts and feeders available - please inquire. 1.) Fine Suntronix MRK OR4-H Power Supply 24V 16 Amp Output 2.) Y Axis Service AmplifierSanyo Denki PY0
Electronics Forum | Mon Sep 20 22:17:04 EDT 2021 | ttheis
SOLVED Upon manually activating the zaxis to drive the spindles down, it was noted that the touch down sensor for spindle #2 was activating at a certain point in the travel without touching anything. I went to look at the adjustment of the sensor
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Thu Apr 17 16:55:32 EDT 2014 | bobpan
Hello, The only thing i can think of is the x&y ribbon cables. I know you said they are good but they could have an intermittent break. I would get a spare set and plug them in with the machine at a slow speed setting and see if it works as normal. A
Electronics Forum | Wed Sep 10 10:25:48 EDT 2003 | r_astom
Jan, Please see our webpage regarding these programs for further details. http://www3.uic.com/__852568c80050acb1.nsf/0/f5455502658b71cc852569ca0045b8cd?OpenDocument The part number for the refurbished Unit Drive in question is 630 111 8123. Also,
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
