Electronics Forum | Sun Sep 24 10:24:50 EDT 2006 | jj Colin
Yes. We are using this system and are very happy with it's performance. JJ
Electronics Forum | Mon Apr 24 04:21:10 EDT 2006 | vpha
I have seen a Spark 400 at Apex Show. It appears to be a good Machine to do rework on BGA and others. I have used a SRT Summit 1100 Machine to do most BGA Reworks and want to have a Machine which can do rework better. Does anyone has any knowledge
Electronics Forum | Mon Mar 20 03:47:16 EST 2006 | Adrian
Hi guys, Has anyone ever had experiance with a Vision Master 150 ?, we have 2 onsite and I am trying to get accurate BGA paste height measurements from this machine, but both the machines are giving me results with huge variations, like +/- 0.2 thou
Electronics Forum | Thu Jan 12 20:11:25 EST 2012 | davef
Isola water pressure. Between a 210°C normal tin lead cycle and a 250°C lead-free assembly cycle, the vapor pressure doubles. Reflow temperature [*C]||Vapor pressure of water [psi] 150||100 200||225 210||260 220||320 230||400 240||480 250||580 300||1
Electronics Forum | Wed Mar 10 14:05:29 EST 2004 | dougt
The 400E has a computer on the bottom of the cabinet with a a Serial/Keyboard Card installed in it. J1 pins 19/20 are the cutters transmit/receive lines on this card, they go through a transition brd and on to the Cutter/Processor brd on the side do
Electronics Forum | Wed Mar 10 08:08:49 EST 2004 | paul_bmc
I am having issues with a CS-400E that I thought I might ask if anyone has any suggestions. The machine may run fine for a while then out of the blue the cutters stop responding or start responding erratically, you have to hit the esc key after ever
Electronics Forum | Sun Apr 04 13:37:53 EDT 2004 | metats
Thanks for everything, it ended up being worn out brushs in the cut and clich motors. A little clean up and some elbow grease and its all ok. Thanks again, Paul
Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt
I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.
Electronics Forum | Wed Mar 10 11:19:59 EST 2004 | mrmaint
Paul, I have seen harness issues in the past that have given some unusual results. The problem we found was that depending on the rotation and position of the cut/clinch unit the opens/shorts were not consistent. The first place i would look is at th
Electronics Forum | Mon Feb 02 16:30:46 EST 2004 | paul_bmc
I have one machine that I am having trouble getting the machine to recognize an offset. I keep getting the error, "When correcting Offset 1: Invalid offset, press 'esc". Does anyone know what I am doing wrong. On another machine I have I keep havi
.gif)
