Electronics Forum | Thu Dec 22 06:46:01 EST 2011 | rameshraja
Dear All, We are doing PCBA's manufacturing,Inprocess we are doing manual soldering, reflow and wave soldering process, As per ISO-7.5.2 Process validation ( Special process ) Soldering process is considered as an special process, hence in order to
Electronics Forum | Mon Jul 15 11:36:18 EDT 2013 | rgduval
Some great legal language here, Dave. Guess some people don't like their knowledge being shared. Probably shouldn't publish it to the interwebs if that's the case.
Electronics Forum | Sat Jul 13 09:56:45 EDT 2013 | davef
Look here for guidelines http://www.sensata.com/supplier/pdf/CQI-17_Soldering_System_Assessment.pdf Special processes" refer to processes that produce outputs whose output cannot be verified before being released to the customer. These products and
Electronics Forum | Thu Dec 22 10:52:32 EST 2011 | davef
[ Removed by demand of Praxiom Research.. See their "request" below] Subject: DMCA copyright infringement takedown notification Date: Fri, 12 Jul 2013 12:52:40 -0600 From: Praxiom Research Group Limited To: , , , Attention: Copyright Agent, S
Electronics Forum | Wed May 25 10:43:46 EDT 2011 | kahrpr
Adding redundancy and audits to the process is the worst option. Audits are a non-Value added expense. Too many companies that have a problems Just throw more inspection into the process trying to filter out process problems or people deficiencies. F
Electronics Forum | Thu Dec 16 11:25:55 EST 2010 | ssager
Thanks guys, It sounds like adding redundancy and audits to the process is the best low cost option.
Electronics Forum | Wed Jun 08 23:36:38 EDT 2011 | grics
KaHrpr is correct. All of the extra 'redundancy' is waste in your process and will work against any goal of being lean. I would suggest establishing a team of individuals to do a C.I. project and conduct a PFMEA and try to determine where any holes
Electronics Forum | Thu Feb 23 02:46:16 EST 2006 | INGE
It isn't an FDA validation. I think Steve has centered the problem. I have already defined all the steps and all the procedures of the process, but now I must run X boards, Y times, through each piece of equipment (as he said before); the question is
Electronics Forum | Wed Feb 22 12:40:41 EST 2006 | russ
Here are some of the things we had to do when we had to validate process. Incoming voltage Air pressure squeegee speed placement accuracy oven stability
Electronics Forum | Wed Dec 15 16:17:30 EST 2010 | rgduval
Sounds like there may be a people problem somewhere in your process. We have a couple of checks set up to aid with capturing first article issues. First, of course, the kit is checked against the BOM to ensure that all of the parts match. Then, we
.gif)
