Electronics Forum: speciality coating systems (Page 1 of 37)

interchangeable stencil frame systems

Electronics Forum | Fri May 04 18:55:49 EDT 2001 | johnthor

actually the "yellow lite" part of my posting was simply spoofing Dave's light up band-aid wrappers. But seriously (again) most high temperature Kapton polyimide film tapes, like 3M #92 and #1205, develop a considerable charge when unrolled or remov

interchangeable stencil frame systems

Electronics Forum | Thu May 03 10:23:33 EDT 2001 | davef

Yes, Alpha's frames help develop upper body strength. All stencils, regardless of the type of frame, can have loose foils. Stencils with removable foils require a specialized storage system for the foils and lots of band-aids. Some foil frame su

Table top conformal coatings systems

Electronics Forum | Thu Feb 23 16:31:09 EST 2012 | hegemon

Could be as simple as a pail full of UR coating and some wire hangars! Conformal coating is brushed on, sprayed on, and parts are dipped too, not to mention the wonderful vacuum process that is paralene. Gotta have a little more info as to your a

Table top conformal coatings systems

Electronics Forum | Thu Feb 23 13:52:01 EST 2012 | cobham1

We are looking to puchase a table top conformal coating system. Can anyone tell me what to look for and are there systems that wont brake the bank.

Table top conformal coatings systems

Electronics Forum | Wed Feb 29 14:37:14 EST 2012 | hegemon

If I am not mistaken you can buy Spray cans of Conformal Coating. For the small batch in the environment you are describing, that might be the ticket. A bit pricey material wise, but clean up is a cinch. A little masking tape, and spray away!

Table top conformal coatings systems

Electronics Forum | Fri Feb 24 07:28:11 EST 2012 | duso02

If you are going to coat very low volumes then just spray it by hand. The automated machines just won't be worth it unless you are going to do a very large run. They are complicated, require constant attention, still require masking the board and are

Table top conformal coatings systems

Electronics Forum | Fri Feb 24 08:02:22 EST 2012 | cobham1

Our production runs normally are 20 piece builds. We don't what to brush because of the brush marks left behind. Reason we wanted a machine is more control then dipping with a tub and modified paper clips. The other problem we have is the company as

Table top conformal coatings systems

Electronics Forum | Thu Mar 01 10:35:06 EST 2012 | duso02

For that low a volume it would be simplest and most economical to just out source the work. If you want, just send me an e-mail and I can give you specific options on what would be best for you., in-house or out-house.

Table top conformal coatings systems

Electronics Forum | Fri Mar 02 11:46:18 EST 2012 | cobham1

I like your idea. Can you send me info my email is bill.capen@cobham.com

PVA conformal coating machine

Electronics Forum | Mon Aug 09 07:13:08 EDT 2010 | raghu

We have PVA 354Bench top conformal coating machine. We are going to procure the Humiseal 1B31 material. Is this material is suitable for this model of machine? Is there any special pecautions to be taken while programming? What are the main problemsd

  1 2 3 4 5 6 7 8 9 10 Next

speciality coating systems searches for Companies, Equipment, Machines, Suppliers & Information