Electronics Forum | Fri Oct 03 04:24:54 EDT 2014 | dcarroway
Does any one have a wiring diagram for an electrovert Omni 10. We are having trouble finding why zone 7 runs over temperature.
Electronics Forum | Mon Oct 06 11:09:20 EDT 2014 | cyber_wolf
I dont have a schematic anymore but its most likely the SSR for that zone or the blower.
Electronics Forum | Wed Oct 08 11:18:41 EDT 2014 | wavemasterlarry
If its like my wave, the t-couple might not be mounted over a whole where the hot air blow out./ mounting it on the hot plate makes it over heat alot.
Electronics Forum | Mon Nov 10 10:57:34 EST 2003 | frank
i have to agree with you all, it seems bad decisions are always the one that are made rather than the logical ones.lets just hope electrovert continues to provide us with the best and dependable solder and cleaning equipment and mpm continues as well
Electronics Forum | Sat Nov 08 21:19:25 EST 2003 | Dean
I have noticed when I call the MPM parts hotline I get Ken at MPM (Franklin). Also, my friend who has worked at mpm for over 10 years mentioned that Camelot has beem moved into the Franklin facility with MPM. There was a large debt load on that tra
Electronics Forum | Wed Nov 05 19:40:25 EST 2003 | Mike Konrad
Here's the official press release... New York, NY (November 5, 2003) -- KPS Special Situations Fund II announced today that it has acquired the stock and related assets of Speedline Technologies, Inc. from Cookson Group, plc for a total consideratio
Electronics Forum | Thu Apr 24 16:34:18 EDT 2003 | pjc
OmniFlo 10 Engineering Data Sheet has been sent to your SMTnet mail box. Its a PDF 818Kb.
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Thu Apr 17 07:47:07 EDT 2014 | emeto
Hello all, does anybody know How to set paralelism on Electrovert OmniFlex 10? I couldn't figure that out on my own, so please help.