Electronics Forum | Thu Mar 03 09:58:59 EST 2005 | Marc
The gears should be wet. This gear box acts like a rear end axle. Not sure of the lubricant but it is like a red transission lube, comes in as complete unit from supplier. You can't get the lube from Speedline since it is sold as a complete unit.
Electronics Forum | Thu Dec 21 09:32:35 EST 2006 | Brandon
Does anyone know of a source other than speedline? I know these can be had for $100. Speedline wants $1600. It is a cooling zone blower motor for a cross blow system. Not the same blower you see on the top of the heating zones. This one mounts from t
Electronics Forum | Tue Sep 29 13:03:01 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, a
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Fri Apr 29 15:17:54 EDT 2022 | glasscake
If the machine was working appropriately before the hard drive failure i would lean on the issue being a configuration issue. Lots of machines have options in their software for different sized motors, limit sensors, IO configs, ext. See if you cant
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
| 1 |
