Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Wed Nov 05 19:40:25 EST 2003 | Mike Konrad
Here's the official press release... New York, NY (November 5, 2003) -- KPS Special Situations Fund II announced today that it has acquired the stock and related assets of Speedline Technologies, Inc. from Cookson Group, plc for a total consideratio
Electronics Forum | Sat Nov 08 21:19:25 EST 2003 | Dean
I have noticed when I call the MPM parts hotline I get Ken at MPM (Franklin). Also, my friend who has worked at mpm for over 10 years mentioned that Camelot has beem moved into the Franklin facility with MPM. There was a large debt load on that tra
Electronics Forum | Mon Nov 10 10:57:34 EST 2003 | frank
i have to agree with you all, it seems bad decisions are always the one that are made rather than the logical ones.lets just hope electrovert continues to provide us with the best and dependable solder and cleaning equipment and mpm continues as well
Electronics Forum | Wed Jul 05 14:55:53 EDT 2023 | robertobsuinc
How can I adjust the stencil frame size on my MPM speedline accela? is there an automatic option or I need to do it manually?
Electronics Forum | Thu Jul 06 12:23:43 EDT 2023 | poly
On my one and I think all of them you need to do it manually. Send the stencil shuttle to front, There's two hex screws either side (4 total) you need to loosen. There a little indicator for the different common sizes. Then send the shuttle to the
Electronics Forum | Fri Oct 05 08:35:29 EDT 2001 | PeteC
I believe this machine is now the MPM UP 100 and is supported thru Speedline Technologies-MPM and is now mfg.'d in Franklin Mass.
Electronics Forum | Thu Jul 02 16:55:27 EDT 2015 | aemery
Been working on MPM printers for 20+ years; it's what I do! (CM, Speedline FSE/Trainer, Independent contractor) If MPM built, I keep them running. AP's to Accela's. info@primetechservices.net 858.449.0007
Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet
We service MPM machines. Tom Nisbet tom@goppm.com 603 765-8814 www.goppm.com
Electronics Forum | Mon Jun 29 08:50:55 EDT 2015 | tdemon69
looking for some one that works on these machine for a living, that my company can higher from time to time to do some work on them.
.gif)
.jpg)
.png)