Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Sat Nov 08 21:19:25 EST 2003 | Dean
I have noticed when I call the MPM parts hotline I get Ken at MPM (Franklin). Also, my friend who has worked at mpm for over 10 years mentioned that Camelot has beem moved into the Franklin facility with MPM. There was a large debt load on that tra
Electronics Forum | Mon Nov 10 10:57:34 EST 2003 | frank
i have to agree with you all, it seems bad decisions are always the one that are made rather than the logical ones.lets just hope electrovert continues to provide us with the best and dependable solder and cleaning equipment and mpm continues as well
Electronics Forum | Wed Nov 05 19:40:25 EST 2003 | Mike Konrad
Here's the official press release... New York, NY (November 5, 2003) -- KPS Special Situations Fund II announced today that it has acquired the stock and related assets of Speedline Technologies, Inc. from Cookson Group, plc for a total consideratio
Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Wed Jul 05 14:55:53 EDT 2023 | robertobsuinc
How can I adjust the stencil frame size on my MPM speedline accela? is there an automatic option or I need to do it manually?
Electronics Forum | Thu Jul 06 12:23:43 EDT 2023 | poly
On my one and I think all of them you need to do it manually. Send the stencil shuttle to front, There's two hex screws either side (4 total) you need to loosen. There a little indicator for the different common sizes. Then send the shuttle to the
Electronics Forum | Tue Jun 29 13:42:20 EDT 2004 | sigmaprint
You will need to set the contact and squeegee zero calibration every time you set up a new product, we do this because the thickness of the substrate (pcb) can change between product and this will effect these calibration settings. The machine does n
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
