Electronics Forum | Mon Jun 25 19:36:36 EDT 2007 | bga_kid
If you calculate CFM using the numbers you have provided you are pulling 1396CFM out of the oven. I am not sure what Hellers spec is but I know a Speedline OmniExcel Air machine should be set at 300CFM. I do know for a fact that to much exhaust can s
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
