Electronics Forum | Sat Dec 10 08:02:18 EST 2005 | davef
Consider: * Your machine supplier * Transition Automation http://www.transitionautomation.com * A couple of years ago, Darby I think, talked here on SMTnet about using a stainless steel blade that he had made. Basically, he provided his stencil fab
Electronics Forum | Thu Dec 08 16:44:18 EST 2005 | eeltec
I am looking for Metal Squeegee blades, 15 7/8" long, angled, for a deHart stencil printer model EL-20. Can you recomend me a good and unexpensive supplier? Thanks Greg
Electronics Forum | Sun Dec 11 22:21:26 EST 2005 | darby
That's correct Dave, have been for over 11years. We are still using them on all lines. For the cost of a 460mm s/s shim at 0.010" thickness you get six blades. Darby.
Electronics Forum | Mon Dec 12 00:52:24 EST 2005 | cindyleng
Dear Greg, We can manufactured various of Metal squeegee blades, pls give me email address, i'll send the picture to you. Tks and B.Rds Cindy Leng HWATALI TECHNOLOGY (HK) CO TEL: 86-755-83016463 FAX: 86-755-83016648 Email: hwatali88@yahoo.com.cn
Electronics Forum | Mon Nov 15 19:08:47 EST 2004 | grayman
For fine pitch components we would suggest slow movement of metal squeegee. The effect of angle is minimal. You may check squeegees from Transition Automation they can help you with the holder and the best squeegee. I do not have the web site, Arman
Electronics Forum | Mon Oct 30 11:01:32 EST 2006 | nodlac
David- We found success with Permalex blades from Transition Automation. http://www.transitionautomation.com/squeegee.html Not that this solves yer problem....
Electronics Forum | Tue Nov 23 20:21:44 EST 1999 | Curtis T.
Does any one have any experience with the transition automation permalex squeegee blade (I called them and they couldn't tell me much), or any blade other than the typical nickle coated spring steel. Part of our production has been moved (by our cus
Electronics Forum | Thu Dec 02 10:32:47 EST 1999 | Boca
Curtis, They have a 'permalex' coating bonded to the metal. We see no signs of flaking. They are pricey but they do work, we had metal blades from the OEM, they were absolute trash (not MPM). We run 16-6 and they last at least 4 to six months in
Electronics Forum | Thu Oct 23 08:13:44 EDT 2003 | davef
The SEMA listing [ http://www.smema.org/smema5.pdf ] says: * D CUT SQUEEGEE: A single diamond edge squeegee which is shaped like an upside down house and made of polyurethane. * FOUR-SIDED DIAMOND EDGE SQUEEGEE: A polyurethane 3/8 x 3/8 four sided, f
Electronics Forum | Wed Jun 13 21:25:48 EDT 2001 | dougk
We've tried the MPM rheo., with excellent results. We saw a decrease in fine-pitch pad coverage rejects from ~20% to bacicially ~0%. Print speeds went from 1-2 in/sec (metal blade) to 4-5 in/sec (rheo.). Could probably go faster. Great throughput. Li