Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Thu Mar 20 16:08:45 EDT 2014 | dave222
NRS, I will check to make sure that the hole in the spindles are not obstructed and that the spindles are not damaged or bent. thank you for the info. I will let report after I check. thank you
Electronics Forum | Mon Sep 20 22:17:04 EDT 2021 | ttheis
SOLVED Upon manually activating the zaxis to drive the spindles down, it was noted that the touch down sensor for spindle #2 was activating at a certain point in the travel without touching anything. I went to look at the adjustment of the sensor
Electronics Forum | Fri May 11 17:28:10 EDT 2012 | peteb
Have you tried adjusting the spindle height? To do this you will need UIC fixture #46315501.
Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Wed Jun 09 17:41:40 EDT 2004 | stevecrowley
Does anyone know of a 3rd party that manufactures the Mirae spindle? We have 5 broken nozzle spindles that need replacing. Also in need of renting or borrowing the Head Offset Jig so as when replacing said spindles we can measure the camera to nozzl
Electronics Forum | Thu May 10 16:48:27 EDT 2012 | markyen
All Professional, I've a GSM 2 flex head (2 beams). Beam 1, spindle 1 and 2 is disable right now. Spindle is not changing nozzle right now. How hard is it to replace the spindle? Does it involve calibration, and can anyone provide me with instructio
Electronics Forum | Tue Jul 19 01:53:53 EDT 2022 | ttheis
We are in process of calibrating one of our GSM machines; we were able to successfully calibrate the front and rear ULC's but when we moved on to calibrate the head we get a spindle runout error midway through the routine (pic attached.) The spindles
Electronics Forum | Mon May 16 09:54:06 EDT 2011 | vickt
This could be the cause. A simple test is as follows: Turn on the clutch for the specific spindle in I/O and use your hand to rotate the z shaft to drive down the spindle. Drive the spindle by hand to the end of travel and try rotating beyond that
Electronics Forum | Fri Jul 14 17:32:36 EDT 2023 | ttheis
Having an issue with changing nozzles on one of our FJ3 heads. We get errors on spindle 5 and 6 when bank-changing nozzles. Event code 31208, unable to find any info on this code. When we use the put nozzles away routine it does it no problem but has
