Electronics Forum | Thu May 12 18:32:02 EDT 2011 | jbaez1
Also... this is ONLY a pick issue? No issues with > placement for those that you do successfully > pick? > > Have the spindles been calibrated > lately? Hi Vickt! thanks for your comments,,during step mode no failure at all, the spindle moves d
Electronics Forum | Sun Apr 30 20:52:33 EDT 2023 | poly
I've got access to all the manuals. Alas my 7 spindle head (flexjet 3 on a gx11s) detects collisions when picking even when no nozzle is in the spindles and they aren't near anything. My other machine is working well.
Electronics Forum | Sat Mar 26 02:38:07 EDT 2011 | evans1001
Had an issue with spindle 2 not coming down and picking parts up, then it was but not placing the part. The other 3 spindles were working fine. Changed the head on the machine but stil had the same issues. Anyone with any ideas. Cheers
Electronics Forum | Fri Jul 14 17:32:36 EDT 2023 | ttheis
Having an issue with changing nozzles on one of our FJ3 heads. We get errors on spindle 5 and 6 when bank-changing nozzles. Event code 31208, unable to find any info on this code. When we use the put nozzles away routine it does it no problem but has
Electronics Forum | Fri Sep 23 04:12:11 EDT 2005 | siverts
Installation/set up of the component shuttle is critical. The shuttle must be perfectly squared and leveled, since it has a 4 spindle pick/place head on it. This shuttle head can pick up to 4 comps. from the shuttle feeders (gang pick) and will deliv
Electronics Forum | Thu May 12 16:24:39 EDT 2011 | vickt
Also... this is ONLY a pick issue? No issues with placement for those that you do successfully pick? Have the spindles been calibrated lately?
Electronics Forum | Wed Jan 31 08:26:36 EST 2007 | geb
I think it might be the feeder banks, that is causing the problem. I've tried picking a SOT-23 component using head 2 spindles 1-4 from a rear feeder bank and it is picking off centre. Doing exactly the same, but putting the feeder in a front bank it
Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Sat Oct 13 14:25:09 EDT 2018 | comatose
Maintenance on the lightning heads is extremely minimal, especially compared to the absolute mess that is flexjet. They just go. Also, you can replace a whole spindle with a new one for something like $700, it only takes a couple minutes and you do
Electronics Forum | Sat Apr 29 12:18:07 EDT 2023 | poly
I have finally got a calibration kit for my single beam multi function Genesis. Calibration finishes successfully, I then attempt to pick a part with the 7 spindle head and it gives me a collision error. The error occurs even when I don't have a no
