Electronics Forum | Wed Jul 27 15:54:44 EDT 2005 | Hiram
Hi everybody, We have wave solder fixtures made of Durapol and multiple wave solder machines. Most likely we�ll use the same pallets for either tin-lead or lead-free solder for a while (of course after washing the pallets). Should we test the palle
Electronics Forum | Wed May 25 18:33:18 EDT 2005 | russ
We have passed testing using this process, I would consider it on a case by case basis however. We are very careful about the quantity of the O.A. that we use. The water soluble flux is gone after cleaning unless it was/could be encapsulated or tra
Electronics Forum | Wed May 25 18:09:47 EDT 2005 | Fluxed_State_of mind
Need some input here..... The fear is that the if we use water soluble flux at the repair operation, that the no-clean encapsulation will capture some of the organic material as it cools down and goes to its original state. The organic material wil
Electronics Forum | Fri May 27 12:09:59 EDT 2005 | saragorcos
You do want to be very careful with potentially entrapped organic materials as they are prone to causing electrical leakage failures particularly around sensitive devices. There is a new clenliness testing tool available that tests a localized area
Electronics Forum | Thu Apr 05 03:19:04 EDT 2018 | myke03o
We are currently in a Clean solder process (SMT+Wave Solder+Washing). Now our management is planning to convert to a No-Clean process in SMT due to limitations of solder availability and reduction of washing process. Question1: Is it possible to was
Electronics Forum | Mon Dec 29 23:35:42 EST 2014 | abhilash4788
Dear All, I'm just a budding engineer in EMS field. Here we used to manufacture different classes of PCBA. I would like to know about different process that need to be considered while manufacturing class 3 product. If we are going for microscopic
Electronics Forum | jandon |
Sat Jan 10 05:48:09 EST 2015
Electronics Forum | Tue Dec 30 09:31:52 EST 2014 | rgduval
I've always approached it like this: Design your processes and perform your work to class three standards, and inspect to the standard that is acceptable. That is, all work should be performed to the highest degree of quality. When the work is ins
Electronics Forum | Tue Jan 06 06:56:26 EST 2015 | stivais
How about rework (touch-up) for Class 3? Some say that you are not allowed to rework anything for Class 3. Though I have not found any proof for this 'requirement' in the standards.
Electronics Forum | Sat Jan 10 05:55:13 EST 2015 | jandon
Rework is acceptable in class 3 but hardware defects shall be documented before rework and rework shall be documented.
