Electronics Forum | Fri Apr 02 14:18:41 EST 1999 | Tony A
Anyone knows what is the optimum squeegee angle for screen printers.
Electronics Forum | Thu Dec 08 16:44:18 EST 2005 | eeltec
I am looking for Metal Squeegee blades, 15 7/8" long, angled, for a deHart stencil printer model EL-20. Can you recomend me a good and unexpensive supplier? Thanks Greg
Electronics Forum | Sat Dec 10 08:02:18 EST 2005 | davef
Consider: * Your machine supplier * Transition Automation http://www.transitionautomation.com * A couple of years ago, Darby I think, talked here on SMTnet about using a stainless steel blade that he had made. Basically, he provided his stencil fab
Electronics Forum | Mon Dec 12 00:52:24 EST 2005 | cindyleng
Dear Greg, We can manufactured various of Metal squeegee blades, pls give me email address, i'll send the picture to you. Tks and B.Rds Cindy Leng HWATALI TECHNOLOGY (HK) CO TEL: 86-755-83016463 FAX: 86-755-83016648 Email: hwatali88@yahoo.com.cn
Electronics Forum | Thu Dec 08 18:52:17 EST 2005 | valuems
Hello Greg I believe a you can get them from JNJ, not sure of the phone number. Try a web site and I know that they have a 1-800 number, so 800 information would find them. Harry
Electronics Forum | Sun Dec 11 22:21:26 EST 2005 | darby
That's correct Dave, have been for over 11years. We are still using them on all lines. For the cost of a 460mm s/s shim at 0.010" thickness you get six blades. Darby.
Electronics Forum | Thu Oct 23 08:13:44 EDT 2003 | davef
The SEMA listing [ http://www.smema.org/smema5.pdf ] says: * D CUT SQUEEGEE: A single diamond edge squeegee which is shaped like an upside down house and made of polyurethane. * FOUR-SIDED DIAMOND EDGE SQUEEGEE: A polyurethane 3/8 x 3/8 four sided, f
Electronics Forum | Fri Aug 18 08:23:43 EDT 2017 | pavel_murtishev
Ultrasonic works fine for squeegees.
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
winsouce.jpg)
