Electronics Forum | Tue Nov 25 12:48:31 EST 2014 | cyber_wolf
Has anyone looked at SPI results across different squeegee blade manufacturers ? We are running Momentums and using the MPM pro-blades. Ive been considering looking at permalex blades again to see if I can maybe squeek out some better yields.
Electronics Forum | Sat Aug 20 15:18:40 EDT 2016 | mahendra
email mskisten@gmail.com for your squeegee Requirements. Thank you, Mahendra.
Electronics Forum | Thu Nov 03 01:20:35 EST 2005 | pavel_murtishev
Good morning, Thank you for assistance. I�m not so experienced with MPM maintenance. Explain me please what is the difference between �squeegee down force� and �squeegee pressure�? Squeegee pressure is set so 5-6 Kg. How can I check squeegee down fo
Electronics Forum | Fri Feb 18 15:24:17 EST 2000 | Dean
Fitness-for-use is a very important aspect of a squeegee. The most delicate and important element of the squeegee is the blade. Regardless of how you store 'em protect the blades! I know MPM has blade covers bud don't know about DEK. I'm sure they
Electronics Forum | Fri Feb 18 15:24:17 EST 2000 | Dean
Fitness-for-use is a very important aspect of a squeegee. The most delicate and important element of the squeegee is the blade. Regardless of how you store 'em protect the blades! I know MPM has blade covers bud don't know about DEK. I'm sure they
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Thu Jun 16 20:29:12 EDT 2011 | dman97
Does anyone know if it is possible to change the distance that the squeegees travel? What i mean is... Is it possible to change where the squeegees start and stop during a print? Our squegees seem to stop right at the edge of the apertures and this
Electronics Forum | Fri Mar 29 16:29:16 EDT 2013 | aemery
Worked on these for many years as a Speedline FSE, now doing my own thing. You could have motion or alignment issues in the printhead. The setting in the INI could be wrong, but unlikely. Or are you just using the wrong squeegees. Without a stenc
Electronics Forum | Fri Feb 20 15:30:07 EST 2015 | superlen
Thanks everyone for the replies. :) Len
Electronics Forum | Wed Jun 13 12:08:22 EDT 2001 | vance
What kind of quality improvements could be expected by implementing MPM's Rheopump instead of using squeegee blades on a stencil printer?
winsouce.jpg)
