Electronics Forum | Tue Mar 17 12:48:41 EDT 2015 | cyber_wolf
Couple things: If the rubber roller that touches the take up wheels is worn you can adjust it. The axle is on an eccentric. Make sure the "teddy bear faces" that adjust the pick point are not grossly different from the left to right sides of the ma
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Thu Nov 18 13:44:50 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:45:20 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:47:25 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel
Electronics Forum | Thu Nov 18 13:52:51 EST 2004 | ehess
I know this is not a SMT machine, but I thought I might find someone on here who could help me. We have an old Universal 6348A Radial lead inserter. The problem we are having is the chain will stop, periodically, before the chain stop status wheel ma
Electronics Forum | Tue Nov 26 09:19:29 EST 2002 | pjc
MPM UltraPrint 2000 2D Inspection Times: QFP 256 pin 16Mil pitch is 7.5 seconds BGA 225 ball 20Mil pitch is 1.8 seconds Find out the DEK times for these devices. Any UP2000 of 1995 mfg. date oand on can be upgraded to the latest software. Concer
Electronics Forum | Fri Oct 30 14:24:50 EST 1998 | Greg Curler
| Does anyone have info on any of these systems (good or bad). We are looking at these 3 types for a new SMT pnp machine. We are low volume high mix. | | Thanks, Dave | Dave, We bought a new machine this year, and like you, narrowed the field o
Electronics Forum | Fri Apr 17 08:51:26 EDT 1998 | Stefan Witte
| We are looking for some basic mechanical parts to | advance parts in the Tape & Reel Carrier Tape using | a stepmotor. The Carrier Tape we use is as per the | EIA Standards and I imagine there are dozens of | companies that make a sprocket gear t