Electronics Forum | Wed Sep 26 12:16:44 EDT 2012 | bwjm
Hi Guys,recently i am facing an issue. Refer to the attached photo. This PCB is high RF speed, gold immersion single layer. After reflow, my solder seems to have black stains on it. I tried with SAC305 paste water soluble and no-clean, both results a
Electronics Forum | Sat Jan 19 02:25:37 EST 2002 | ianchan
Hi, Have a board run, using 63/37 Water Souble (WS) process. during the reflow setup time, we had unsolder issues on a leadless bump chip carrier (BCC) IC level package. To rectify the unsolder rejects, we adjusted the reflow time from 25-55sec into
Electronics Forum | Mon Jan 28 07:48:18 EST 2002 | cnotebaert
Did you perform a cleanliness test on the boards? did it pass? if yes whats the issue? visual attributes like this will not effect form fit or function of the device. Finding this under 30X, wow, why 30X????
Electronics Forum | Fri Feb 01 03:03:08 EST 2002 | madreindeer
Hi, That is very common in WS pastes.It is white residue (Salt) Usually it�s not dangerous it only looking bad. I think best way would be contact your paste supplier and they should know what would take a stain off if not, change supplier. There i
Electronics Forum | Thu Feb 12 08:35:22 EST 2015 | davef
Solder mask is intended to protect the traces from the soldering process. That's it. [Tried to upload a picture. It's broken.]
Electronics Forum | Thu May 19 03:39:04 EDT 2016 | jpcwg
Design application software in resistance welding layer options to carry on the design, can put the resistance welding options this functionality, born PCB board factory to actual production of PCB design are window. we are professional PCB manufac
Electronics Forum | Wed Feb 11 14:55:52 EST 2015 | erezah
we received assembled PCBs with spots that look like a bleach spots all over the PS and CS . The board house said that this is normal due to flux aqueous wash process. Can it cause problems (e.g. corrosion ) in the long run or cause issues when wor
Electronics Forum | Mon May 09 11:29:05 EDT 2016 | jpal
I wanted to bump this up. I am having the same problems. I cannot convince folks it is a solder mask issue and not our process issue, even though it shows up after wave and wash. I can heat the boards and even send them back through the wave preheate
Electronics Forum | Wed Feb 11 17:04:47 EST 2015 | davef
A-610E, 10.7.4 covers solder mask discoloration. Use that for your disposition In a previous thread, Boardhouse told us "Here are a couple of things that can affect color. * Material color is the major, * Matte green from Enthone would be different
Electronics Forum | Thu Feb 12 12:30:16 EST 2015 | stevezeva
I remembered something from the TechNet a long time ago about heating the board with a heat gun to see if the white spots disappear. I searched the archives and found this from Bill Kenyon: Quick identification of solder mask white spots- if it is t
