Electronics Forum | Tue Mar 18 09:11:14 EST 2003 | Rob C
With a standard valve and no-clean solder paste you may get a few good dots. But, repeatability will be terrible too many variable, air-pressure, board height (two post nozzle), valve time on/off, retract height, retract time, etc... A RMA paste wi
Electronics Forum | Thu Jun 10 13:29:21 EDT 2021 | edgar_smt_ap
Good morning. What should be the Oxygen content Standard in an Oven? Here in my company, we have an ERSA reflow Oven, and we work with Lead Free solder paste. According to Work Standard documents send by my company corporate, the PPM Oxygen conte
Electronics Forum | Fri Dec 10 02:42:58 EST 2021 | hello112
SMT stencil standard: measure the four corners and the middle, target value is 26N/CM or more
Electronics Forum | Wed Apr 11 20:58:12 EDT 2018 | jacobidiego
YES to the first question in some points of the board. Bulky, to the second question when it is not in short. What you say about the PAD height, helped me to understand why the SPI shows weird values for other measurements. I am currently doing test
Electronics Forum | Tue Jul 08 06:00:29 EDT 2003 | iman
As part of our process/quality improvement review, it was raised thru' our findings that its a good mfg practice to monitor the incoming solder paste quality (as part of the indirect materials). We get one-page "outgoing QC" vendor reports with each
Electronics Forum | Mon Jan 09 23:24:47 EST 2017 | saju86ece
Hi, We are doing pin in paste reflow process in one our product ( but paste printed on bottom side of the board and top side will be assembled through hole component)in which faced cold solder issue in THT capacitor location after reflow. The solder
Electronics Forum | Mon Dec 20 12:50:27 EST 1999 | Wolfgang Busko
Hi Pascal, 0,65mm pitch normally isn�t much of a problem. With 90�m CU I don�t have any experience but would like to know what deviation from nominal value for the pads you get with different PCB-deliveries. In short, for the standard Cu=35�m we se
Electronics Forum | Wed Jan 08 22:33:24 EST 2003 | jonfox
1. Do you have the necessary equipment to take on such a task and 2. Why? My only guess is that you are looking to find the probability or likelihood of a particular observation and / or a "confidence" score on your other equipment. This is just a
Electronics Forum | Sat Apr 21 04:39:45 EDT 2012 | brotakul
I am using different equipements for SPI such as Koh Young and Cyber Optics machines. I am looking for implementing a general procedure (SWP) for setting LSL's and USL's on the products on which the customer does not specify any limits on the solder
Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose
Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc
winsouce.jpg)
