Electronics Forum | Tue Nov 20 19:08:15 EST 2007 | Peter
Hello, I would like to ask for opinion on an epoxy application. We apply RTV to bond and secure 2 electronic devices on a PCB. But after noticing the RTV bond breaking off during vibration test, our customer has specs in a 5min 2-part epoxy (made
Electronics Forum | Sat Feb 03 13:33:30 EST 2007 | Scotty
Anyone out there in the Cyber SMT world have success/experience utilizing conductive adhesives as a substitute for typical eutectic alloys? Application is for a Single sided SMT Process. With a reliability life span of 8 hours. Forum feedback could
Electronics Forum | Tue Aug 30 12:08:09 EDT 2005 | slthomas
The answer for us at my previous employer was water soluble flux. Wash the board, no residue. If you're not set up to wash (needing a washer, DI water source, waste treatment, ventilation, etc.) it can be expensive and space consuming. Do some resea
Electronics Forum | Thu Feb 13 14:44:37 EST 2003 | jonfox
One more follow up link... Microsoft Access http://www.microsoft.com/office/access/default.asp You mentioned that you do some applications in house, a little Visual Basic and you can make some really usefull apllications out of MS Access. A LOT LE
Electronics Forum | Thu Feb 13 15:59:08 EST 2003 | genny
Yes Access is a definite option. We have an in-house built and tailored MRP package, that started out with Access and VB. I am not sure if it is still solely based on that or not. We have tailored it so much and worked with it so much that I doubt
Electronics Forum | Fri Jul 23 08:20:01 EDT 2004 | contact@go-cam.com
At the address http://www.go-cam.com there is a new cam software. You download the application. You can create your parts and machining option. You upload your part and obtain by mail in few minutes your blocks. The free version is a full version.
Electronics Forum | Wed Jul 07 12:07:08 EDT 2004 | stevecrowley
Good day all, We recently replaced the CTU and RTU hard drives and re-loaded the Q-soft2 application. We now get an error message on the GUI saying Qserve.vxd hooking error #4 . During the process we tested the shared RAM and when the GUI sends a m
Electronics Forum | Fri Mar 07 10:55:51 EST 2008 | slthomas
Not sure if you need help with the calculations or the application, so from the beginning: d=defective parts, p=number of parts, dpm=defects per million parts In a nutshell, d/p=dpm/1000000, so dpm=d/p*1000000 We use dpmo (defects per million op
Electronics Forum | Sat Jul 06 13:21:58 EDT 2013 | impressx
Hi Sarason, I am really interested in exporting these old 740 files directly from our purchasing application that I wrote during the years. I've got a couple of customers who use variant assemblies and panelization of boards. The flexcad solution is
Electronics Forum | Thu Mar 19 11:43:13 EDT 2020 | kylehunter
Hey all. We have an assembleon Opal Xii. Does anyone have a copy of, or know where we could obtain a copy of the offline programming software? Having to do all setup on the machine is starting to become an awful and inefficient solution. I've asked a
winsouce.jpg)