Electronics Forum | Wed Jun 11 10:01:24 EDT 2014 | isd_jwendell
I do not know the Juki machines, but on my Essemtec I need to turn on the vac after the nozzle is down for 0402 parts. I also cannot touch/hit the current part/tape because it tends to flip the next part from the tape bounce. Then there is also the t
Electronics Forum | Mon Feb 21 03:56:34 EST 2005 | abhirami
Agree with Davef. Smaller the chip, more the static charge. I used to see this even with normal chips. Get an ionizer blow. It should solve your problem. May be switch to antistatic tape if affordable.Regards. GV
Electronics Forum | Sat Feb 19 09:31:30 EST 2005 | davef
Potential causes are: * Static charge [get a deionizing fan] * Adhesive on the inside of the cover tape [fix your supplier]
Electronics Forum | Tue Nov 08 19:25:14 EST 2011 | isd_jwendell
I do not have a answer for you, but it sounds like electro-static charge is making air-borne particles stick to the machine. What are the air handling conditions? Could be you need a better filtration system. I use a HEPA filter system. I've always w
Electronics Forum | Mon Mar 05 17:54:07 EST 2012 | swag
Three ideas for you: 1) Make sure nozzle tips are clean. 2) Check coplanarity of leads to bottom of body. If leads are above body, it could be the are not contacting paste well. 3) Investigate static charge in the parts caused by the feeder or
Electronics Forum | Fri Jun 16 10:32:30 EDT 2006 | pms
Thanks for the info Chris, I'll check into your suggestions. We seem to be having the problem with all/most of the TM8FC magazines. I'm looking for a common denominator. Has any one ever experienced static electricity on the cover tape causing the c
Electronics Forum | Mon Jan 11 21:34:37 EST 1999 | Dave f
| I know that static concerns are very important in your work. Are static concerns eliminated by the antic-static devices you wear or which are in your environment, or do the hand tools you use, such as picks, tweezers and brushes, need to be anti-st
| 1 |
