Electronics Forum | Thu Aug 27 18:22:37 EDT 2009 | zombie
Hello, thanks for the help. Since this is only for prototypes we can avoid lead-free. Also our boards are not that big or thick. On the other side, our parts are small, the smallest is 1.5x1mm. Would the DRS24 work? What brand is usally more affor
Electronics Forum | Tue Apr 13 14:49:15 EDT 2010 | davef
90%) from the sample, and the bake time and temperature specified herein are minimums. To improve test accuracy, or to prevent heat damage, other bake parameters may be AABUS. 2 Applicable Documents IPC-QL-653 Certification of Facilities that Inspect
Electronics Forum | Wed Nov 21 15:58:23 EST 2012 | rway
Before you go out and spend 60K on a rework system, you need to look at what technologies you are prototyping with. I'm speaking common-sense of course. A cheap rework system such as Pace MBT systems will allow you to rework most components. For m
Electronics Forum | Mon Nov 17 07:15:36 EST 2014 | garym4569
If you have feeders that you want to always stay on the same machine/position, enter them in the permanent data for the machine in the MSL setup. That is a simple way to reserve locations. Also, the optimization can use any common parts set in perm
Electronics Forum | Mon Aug 10 15:15:17 EDT 2009 | indity
I have very little knowledge of pick and place machines or assembly, and was hoping someone could give me some advice of where to start looking. I do learn quickly so I am not afraid of challenges or learning through mistakes. I need to produce abou
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Wed Aug 06 14:52:15 EDT 2003 | cyber_wolf
Checking the vacuum at all stations is a good place to start. A vacuum guage with a piece of hose attached to a CP nozzle is a very handy tool to have. If you notice less vacuum at any one of the stations, you can start by looking @ the spool valves
1 |