Electronics Forum | Tue Apr 13 18:12:54 EDT 1999 | David
| I am looking for a BGA rework/placement system and would like any experience that you have had. I am looking for a system that is reasonable for the placment, removing and re-balling | | thank you | You might want to look at Advanced Techniques
Electronics Forum | Thu Nov 26 03:59:59 EST 2020 | ravikumargv
Dear All... Greetings.... Recently My S27HM machine MC had problem and i replaced another same S27HM machine MC and updated BIOS and installed RMOS1&2 after Distribution successfully completed power off the machine and power On the machine, afte
Electronics Forum | Fri Apr 22 07:22:03 EDT 2005 | Gene
Unfortunately the answer is no. These machines could not be run without line computer because the station computer does not have a program control software, it has the hardware station control only. Computers for SP-120 and HS -180 are the same but
Electronics Forum | Tue Jan 21 18:44:00 EST 2020 | victor
Hello, Could you please help with getting the Station Computer installation manual for 4XXX and 5XXX station software versions? Cheers, Victor
Electronics Forum | Tue Sep 24 11:15:45 EDT 2013 | James Whitehouse
Hi, Boot the station computer with a dos disk, open real.ma with an editor, find the adresse near the top and get it to match what you have configured in your line computer. BR
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Thu Mar 25 05:51:24 EST 1999 | Shahar Re'em
maybe someone can help me with this problem I have 4 S-20 machines on 3 lines and I notice that when I omit a component on the station computer other components are not assembled and on each PCB it's different components and not the same order. TN
Electronics Forum | Fri Jun 26 06:32:33 EDT 2020 | dltechltd
Dear Victor, We have figured out what caused the error: One of it's MVS ICOS card had parity error (The MC reported that error too as seen in the previous pictures). We could see RED LED Light on the card, and we have pulled out, and checked: PAR_ER
Electronics Forum | Tue Jan 26 12:15:45 EST 2016 | mjscottinnc
We recently purchased a used HS50 and we are trying to get it up and running. We are completely new to SiPlace and I have a few questions about terminology. Machine Computer, Station Computer, and Line Computer. There appear to be two computers in th
Electronics Forum | Tue Nov 17 07:37:19 EST 2015 | micropak
Hello I got a SiPlace 80-S20 machine which had a damaged hard drive in MC. I changed HDD and re-installed RMOS + MC from floppies. Then I turned on the machine (without any Line Computer). The software on Station computer wouldn't go past the "Soft
.gif)
winsouce.jpg)
