Electronics Forum | Tue Mar 19 13:22:13 EDT 2019 | lapskrfc
Dear all, I'm considering to buy a nice rework station for our lab. We are not gonna do mass production and the smallest components that we will be soldering is in the order of 0201 smd components. Actually, I'm considering the following three machi
Electronics Forum | Thu Aug 01 13:28:21 EDT 2019 | solderingpro
JBC is a great station (no doubt) - I've had the opportunity to use both. I suppose it depends on who is flipping the bill. Performance wise, the QUICK TS Series is nearly identical to the JBC Station and consumables are a fraction of the cost. Ch
Electronics Forum | Fri Dec 17 09:04:56 EST 2021 | hello112
Someone shared it online, I didn't download it
Electronics Forum | Tue Jun 16 15:06:48 EDT 1998 | Bob Willis
I must say that I feel when the board has been correclty designed with corner marks on the edge of the BGA the optical systems are not necessary on 0.50/0.060" pitch. I like both air and IR the IR has the major benifit that you do not need all the ex
Electronics Forum | Sun Jan 03 04:26:36 EST 2016 | sarkhosh
Hi Dear sir I have a question,My F5HM machine have mc hdd problem and dosen't boot. would you please let me know where can I download or find the mc installer floppy. with regards Masih Email: sarkhoshm@gmail.com
Electronics Forum | Sat Mar 04 17:41:38 EST 2006 | samir
Wavemaster Larry must be new to the forum. What a nut! Sounds like a dude who needs to get his internet access taken away. In Riyadh, Larry, you'd get your arms sawed off for those comments! Grant is right. Hardware-wise, all thermal profilers
Electronics Forum | Wed Jun 04 15:06:35 EDT 2008 | locostpp
Hi Base, I guess your right - due to the complexity of the software we plan on keeping the source code under our control BUT we will not be dongling or protecting it in any other way and we will be publishing the program on our website. We will pub
Electronics Forum | Thu May 03 15:02:59 EDT 2018 | solderingpro
Bob Willis (was the first I knew of) that has a splatter test that can be performed over a ceramic hot plate or the like. The concept is pretty straight forward, using a zoned circle, users can introduce the solder wire at a consistent rate and coun
Electronics Forum | Thu Aug 08 16:18:22 EDT 2013 | horchak
Placing and re-flowing the shield is of course the most economical. But once the shield is placed and reflowed this all but rules out inspection test and rework. Reflow should not be an issue if you have a decent forced air convection oven. You may w
Electronics Forum | Mon Apr 01 13:40:38 EDT 2019 | lapskrfc
Hi all, I'm thinking of adding a high-end rework station to my lab. Budget-wise I can basically afford all the solutions from Finetech, Pace, Ersa, and others. However, I'm not sure which one to go with. I'm considering Finetech Core-plus and Pace
.gif)
